Abstract:In operation, residual stresses will superimpose with load stresses affecting service life of welded constructions. Therefore, knowledge of the exact residual stress state is of great interest already in the design state. Experimental determination of residual stresses is possible using destructive and non-destructive methods. Especially for larger structures and small batch sizes destructive measuring techniques can be neglected. Non-destructive methods, however, do have process-specific disadvantages such as the limited resolution. Furthermore, residual stress gradients in the direction of sheet thickness cannot be determined. An alternative approach would be the virtualization of the design using the finite element method (FEM). The application of FEM gives an insight into residual stresses at each point of the computed model, in particular at areas which are not accessible to measurement. However, the use of the FEM for residual stress calculation is subject to certain limits and error sources due to the fine discretization and the high degree of non-linearity. In particular, the calculation of multi-layer welds will reach high computation times, even with high available computing capacities. Therefore, the calculation's practical benefit is hardly recognizable. This known issue is often counteracted with radical simplification of the welding task to be calculated. Simplification approaches such as reduction of layer numbers or semi-transient calculations result in manageable computing times, but can also lead to result accuracies, the quality of which must be questioned. This led to the following questioning. Which simplification strategies are applicable in numerical welding simulation in order to achieve acceptable accuracy by means of an application-oriented manner? For this purpose, reference models were produced that were experimentally verified. On this basis, simplification approaches were investigated numerically and their effects on result quality were quantified. It could be shown that most of the commonly used simplification approaches for the calculation of residual stresses and distortions are only partially permissible, if any.

Residual Notch Stress Intensity Factor assessment via 3D welding numerical simulation: influence of power input

Estimation of Residual Stresses by Nanoindentation in an Experimental High Strength Microalloyed Steel Subjected to Rapid Thermal Cycles

Assessing the Residual Stresses in Dissimilar Welded Joint: Depth-Sensing Indentation Testing and Numerical Simulation

A physically consistent 2D residual stress model for approximating 3D effects in welding

An Insight into the Creep-Fatigue Damage Localization in Welded Joints Based on Crystal Plasticity Finite Element Method

Numerical Simulation of Welding for Residual Stress Prediction of Low Carbon Steel

Evaluation of Residual Stress Fields in Friction Stir Welded Zone Based on the Plastic Strain Increment and Mises Yield Criterion

Residual Stresses Simulation for Friction Stir Welded Joint

Numerical Analysis of Low-Cycle Fatigue Using the Direct Cyclic Method Considering Laser Welding Residual Stress

Numerical and experimental study on thermal-metallurgical-mechanical behavior of high-strength steel welded joint

A new experimental method to study the influence of welding residual stresses on fatigue crack propagation

Residual stresses with time-independent cyclic plasticity in finite element analysis of welded joints

Re-Distribution of Welding Residual Stress in Fatigue Crack Propagation Considering Elastic–Plastic Behavior

Uncertainty Quantification of Fatigue Life Prediction in Welded Structures Using Microstructure-Based Simulations

Welding residual stress behavior under mechanical loading

Simplified residual stress and distortion calculations of multi-pass welds and their possible influence on result quality

Numerical Investigations on Residual Stress in Laser Penetration Welding Process of Ultrafine-Grained Steel

Residual stress effects on fatigue crack growth in different regions of aluminum alloy 7050 friction stir weld

Numerical Simulation of Fatigue Crack Growth and Fracture in Welded Joints Using XFEM—A Review of Case Studies

Notch energy-based low and high cycle fatigue assessment of load-carrying cruciform welded joints considering the strength mismatch

Fatigue Strength Assessment of Friction Welds under Consideration of Residual Stress