Abstract:Microaccelerometers using piezoelectric lead zirconate titanate (PZT) thin films have attracted much interest due to their simple structure and potentially high sensitivity. In this paper, we present a theoretical model for a microaccelerometer with four suspended flexural PZT-on-silicon beams and a central proof mass configuration. The model takes into account the effect of device geometry and elastic properties of the piezoelectric film, and agrees well with the results obtained by the finite element analysis. This study shows that the accelerometer sensitivity decreases with increases in the beam width, in the thickness of the bilayer beams, and in the elastic modulus of the mechanical microstructure. Increases in the beam length increase sensitivity. For a fixed beam thickness, a maximum sensitivity exists for appropriate PZT/Si thickness ratio. In addition, it is found that with appropriate geometrical dimensions, both high sensitivity and broad frequency bandwidth can be achieved. The calculation of the stress distribution in the suspended PZT/Si beam structure when the device is subjected to large vibrational acceleration indicates that the thin film microaccelerometer can stand extremely large g conditions with very good mechanical reliability. In the dynamic analysis, it is found that both analytical model and finite element modeling give very close results of the resonance frequency of the device. The results of this study can be readily applied to on-chip piezoelectric microaccelerometer design and its structural optimization.

Design and Simulation of Four-Beam Piezoelectric Accelerometer with Slot Substrate

Analysis of Four-Beam Piezoelectric Accelerometer Based on ANSYS

Piezoresistive Slot-Cantilever Type Accelerometer Inspired from Spider'S Slit Sensilla

Analysis and Design of a Novel Piezoresistive Accelerometer with Axially Stressed Self-Supporting Sensing Beams

High Sensitivity MEMS Accelerometer Using PZT-Based Four L-Shaped Beam Structure

High Performance Piezoresistive Accelerometer Based on the Slot Etching in the EB(eight-beam) Structure

A Novel Tri-Axial Piezoelectric MEMS Accelerometer with Folded Beams

Design and Characteristics of a Two-Axis Piezoelectric Accelerometer With Right Angle Cantilever Beam

Design and Simulation for Tri-Axial Piezoresistive Mems Accelerometer

A Two-Axis MEMS Piezoresistive In-Plane Accelerometer with Pure Axially Deformed Microbeams

Design of a Beam-Membrane Piezoresistive Accelerometer Based on MEMS Technology

Design And Fabrication Of A Slanted-Beam Mems Accelerometer

Design & Fabrication of a MEMS Piezoresistive Accelerometer with Beam-Film Combined Structure

An improved structural design for accelerometers based on slotted eight-beam structure

Analysis of Thin Film Piezoelectric Microaccelerometer Using Analytical and Finite Element Modeling

Design and Simulation of Capacitive, Piezoresistive and Piezoelectric Triaxial Accelerometers Using a Highly Symmetrical Quad-Beam Structure

Modeling and Simulation of A Silicon Integration Tri-Axial Piezoresistive MEMS Accelerometer Chip Used for High Impact Test

Analysis of Transverse Sensitivity in Eight-beam Piezoresistive Micro-accelerometer

Design and Simulation of a Silicon Beam Resonant Accelerometer

Static Analysis of Thin Film Piezoelectric Micro-Accelerometer Using Analytical and Finite Element Modeling

Design and Simulation of A Novel Highly Symmetrical Piezoelectric Triaxial Accelerometer