Abstract:In this paper, the competing requirements of material strength, casting formation and residual stress are considered in the design of a large bulkhead integral isothermal forging die using a design approach that incorporates an outer ring plus a die body. Thermal stress assembly was conducted to resolve the various manufacturing issues encountered in the production of this large-scale casting. This paper also proposes a design method for an expansion joint and material-saving holes to homogenize the cross-sectional thickness of the casting die by solving problems associated with defects and hot cracking during the casting process. The finite element method was used based on the equivalent liquid level descending method, the Niyama criterion, etc., to analyze the pouring of the sand model with different risers to choose the casting process. To resolve the occurrence of hot cracks during production, the design was optimized and the process was improved in combining with the simulation analysis result, after which carrying out another finite element analysis and by re-verifying the production process again. The results show that the simulated porosity, shrinkage and stress distribution are in accord with the practical production status. Based on the mechanical properties and a microstructure analysis, the tension strength of the K3 casting die at 950 °C is approximately 635 MPa, and the microstructures are typical dendrites. However, through the simulation, practical production, and analysis of the mechanical properties and microstructure, the die design method proposed in this paper offers benefits in solving casting forming problems and hot cracking of an integral oversized titanium bulkhead casting die, and a K3 superalloy die with a weight of 7.8 tons was successfully cast.

Principals of final forging process in modeling and simulating large-scale head

Study on Simulation of Stamping Forming and Die Surface Optimization of Aluminum Alloy Plate

On the Size Effects in Micro/meso Semisolid Extrusion–forging of A356 Aluminum Alloy

Modeling and Numerical Simulation Research on Hollow Steel Ingot Forging Process of Heavy Cylinder Forging

Numerical Simulation Research on Final Forging Process of 700MW Class Heavy Hydro-generator Shaft

3D FE modeling simulation of the double-roll hot rotary forging of large diameter thin-walled metal disk

Investigation on hollow steel ingot forging process of heavy cylinder forging

Simulation on Forming Uniformity of Nuclear Main Pipe Forging

Forming of Inner Faults Originating from Inclusions in the Heavy Forgings and the Process of Forging Control

Research on Heavy Hollow Ingot Forging Process

Numerical simulation and experiment on hot forging of high-Mn steel turnout core

Numerical simulation and experimental validation of microstructure evolution during the upsetting process of a large size martensitic stainless steel forging

Numerical Modelling of Chamfer Billet of High Carbon Steel During Continuous Casting

Casting Design Optimization Using Numerical Simulation of Precision Forging Die for Large Titanium Alloy Integral Bulkhead

Research on Rotatory Deformation Uniformity and Compaction Effect of Super-heavy Hollow Steel Ingot

Optimal design of a multi-ram forging mold for large-diameter valve bodies

Study on Rational Width ratio of Anvil and Reduction in FM Forging Process

Numerical Model Simulation of the Double-Roll Rotary Forging of Large Diameter Thin-Walled Disk

SIMULATION ANALYSIS OF WHEEL BEARING FORGING PROCESS BASED ON DEFORM

Size effects on process performance and product quality in progressive microforming of shafted gears revealed by experiment and numerical modeling