Abstract:In the present work, the gasification performances of two pairs of raw and torrefied biomasses, including raw forest residue and torrefied forest residue, and raw spruce and torrefied spruce in a high-temperature entrained-flow reactor, are numerically examined and compared to each other using a Eulerian-Lagrangian CFD model developed based on OpenFOAM. Moreover, the sensitivities of three important operating parameters (excess air ratio, steam/carbon molar ratio, and biomass particle diameter), which vary in the range of practical significance, are also tested. The calculated results are analyzed both qualitatively and quantitatively by five indicators: isothermal profiles, char consumption rate, gas compositions, species yield, and carbon conversion along the reactor length. The obtained results show that torrefied biomass can increase the maximum temperature in the reactor as compared to its raw parent fuel. During gasification, CO, H-2, and CO2 are the major species in the product gas and CH4 accounts for only a very small fraction of the syngas at such a high operating temperature of 1400 degrees C. As expected, the higher the excess air ratio, the lower the H-2 yield and higher CO2 production and carbon conversion; a rise in the steam/carbon molar ratio promotes the H-2 yield but reduces the CO production; and both the H-2 and CO yields and carbon conversion decrease with increasing particle diameter. In addition, three reaction zones can be recognized from the carbon conversion along the reactor length, and such information is useful for optimal reactor design. In all cases, torrefaction consistently reduces both the H-2 production and carbon conversion as compared to its raw biomass under the same operating conditions, which suggests that torrefied biomass requires a bigger length entrained-flow gasifier or longer particle residence time to achieve the same level of conversion as that for its raw biomass.

FLOW FIELD SIMULATIONS AND EXPERIMENT OF IMPROVED AIR SUPPLY UNITS FOR UPDRAFT-BIOMASS GASIFIER

CFD simulation of cross flow in multi-tubular fixed-bed reactor of industrial level

CFD investigation of the complex multiphase flow of biomass gasification in industrial-scale dual fluidized bed reactor

Comparison of Gasification Performances Between Raw and Torrefied Biomasses in an Air-Blown Fluidized-Bed Gasifier

Influence of Torrefaction on Biomass Gasification Performance in A High-Temperature Entrained-Flow Reactor

Numerical simulation of gasification characteristics in a circulating fluidized bed biomass gasifiers

Multi-Scale Simulation of Biomass Gasification in Fluidized Beds

Three-dimensional simulation of biomass gasification in a full-loop pilot-scale dual fluidized bed with complex geometric structure

Effects of operating conditions and reactor structure on biomass entrained-flow gasification

Study of the Gasification Performance of a Downdraft Type Biomass Gasifier

EXPERIMENTATION STUDY ON NEW TYPE CWS GASIFIER AT COLD STATE

Three-dimensional full-loop simulation of biomass gasification in dual fluidized bed

Numerical study of biomass gasification in a 0.3 MWth full-loop circulating fluidized bed gasifier

Study on the Modeling of Staged Entrained Flow Gasifier

Study of biomass gasification in an industrial-scale dual circulating fluidized bed (DCFB) using the Eulerian-Lagrangian method

Numerical investigation of gas thermal property in the gasification process of a spouted bed gasifier

Numerical Simulation of an Improved Updraft Biomass Gasifier Based on Aspen Plus

Effect of geometric configuration on hydrodynamics, heat transfer and RTD in a pilot-scale biomass pyrolysis vapor-phase upgrading reactor

Analysis of Operational Problems and Improvement Measures for Biomass-Circulating Fluidized Bed Gasifiers

Effect of Second Airflow on Three- Dimensional Velocity Distribution in Staged Coal Gasifier

Pilot-scale study on downdraft gasification of municipal solid waste with mass and energy balance analysis