Abstract:Recent decades have seen a growing concern about ever-increasing green house gas (GHG) emissions and depletion of fossil fuels. Polygeneration, a multi-input multi-output energy system, provides huge opportunities to tackle these problems due to its superior performances over conventional energy systems in terms of energy conversion efficiency and GHG emissions. Many approaches have been made in process design and analysis of polygeneration energy systems, but most of them focus on using coal gasification as the only way to provide gas for downstream utilization. Coke oven gas, another gas source with huge capacity, however, has not received enough attention in polygeneration process design, and researches in this field are still rather limited. In this paper, we present a dual-gas sourced polygeneration process design which uses both gasification gas and coke oven gas and produces methanol, dimethyl ether (DME), and dimethyl carbonate (DMC) in an integrated catalysis procedure. Gasification gas and coke oven gas are converted to synthesis gas, or syngas, via a catalytic reforming procedure, where the ratio between carbon monoxide and hydrogen in the syngas is carefully adjusted according to specific requirements of downstream chemical synthesis reactions. An integrated catalysis procedure follows, where DME is synthesized from the fresh syngas first, unconverted syngas is then sent to a methanol synthesis unit to produce methanol, and part of the methanol is further converted to DMC in a DMC synthesis unit. Based on the proposed process design, an exergoeconomic analysis and an exergy cost distribution diagram are presented, from which the production cost of a product over each functional block of the process can be easily obtained. Analysis results show that the largest exergy loss occurs in an exothermic reformer, accounting 60.4 percent of the total exergy loss. The exergy cost distribution diagram indicates that DMC has the highest exergy cost, followed by DME and methanol, and it is economically favorable to use the exhaust gas from the chemical synthesis block for power generation.

COST COMPARISON OF DIMETHYL ETHER (DME) VIA MULTIPLE COAL DERIVED PATHWAYS

Techno-Economic Analysis of Methanol to Propylene Process

Technical and Economic Analysis of Some Dimethyl Ether Production Technologies

COST COMPARISON OF HYDROGEN VIA MULTIPLE COAL-DERIVED PATHWAYS

Study on injection characteristics of diesel and DME

Techno-economic assessment of renewable dimethyl ether production pathways from hydrogen and carbon dioxide in the context of power-to-X

Life cycle energy consumption, environmental impact, and costing assessment of coal to ethylene glycol processes via dimethyl oxalate and formaldehyde

Study On Systems Based On Coal And Natural Gas For Producing Dimethyl Ether

Design and analysis of a new DME production process with power cogeneration

Study on Several Versions of Dimethyl Ether Production for Resolving the Natural Gas Utilization Problem in China

Analysis on Perspective and Problems of Methanol-DME Economy in China

Comparative Investigation of Different CO2 Capture Technologies for Coal to Ethylene Glycol Process

Experimental study of improved two step synthesis for DME production

PROCESS SIMULATION AND 3E ASSESSMENT OF THREE DIMETHYL ETHER PRODUCTION SYSTEMS IN CHINA

Life cycle water footprint and carbon footprint analysis of coal gasification to clean fuel dimethyl ether

REVIEW OF DIMETHYL ETHER RESEARCHES IN CHINA

CO2-to-methanol: Economic and environmental comparison of emerging and established technologies with dry reforming and methane pyrolysis

A novel energy-efficient process of converting CO2 to dimethyl ether with techno-economic and environmental evaluation

A dual-gas sourced integrated methanol/DME/DMC catalysis approach to polygeneration energy systems design and an exergoeconomic analysis

An economic analysis of twenty light olefin production pathways

Feasibility Study of Renewable E-Methanol Production: A Substitution Pathway from Blue to Green