Abstract:Recent decades have seen a growing concern about ever-increasing green house gas (GHG) emissions and depletion of fossil fuels. Polygeneration, a multi-input multi-output energy system, provides huge opportunities to tackle these problems due to its superior performances over conventional energy systems in terms of energy conversion efficiency and GHG emissions. Many approaches have been made in process design and analysis of polygeneration energy systems, but most of them focus on using coal gasification as the only way to provide gas for downstream utilization. Coke oven gas, another gas source with huge capacity, however, has not received enough attention in polygeneration process design, and researches in this field are still rather limited. In this paper, we present a dual-gas sourced polygeneration process design which uses both gasification gas and coke oven gas and produces methanol, dimethyl ether (DME), and dimethyl carbonate (DMC) in an integrated catalysis procedure. Gasification gas and coke oven gas are converted to synthesis gas, or syngas, via a catalytic reforming procedure, where the ratio between carbon monoxide and hydrogen in the syngas is carefully adjusted according to specific requirements of downstream chemical synthesis reactions. An integrated catalysis procedure follows, where DME is synthesized from the fresh syngas first, unconverted syngas is then sent to a methanol synthesis unit to produce methanol, and part of the methanol is further converted to DMC in a DMC synthesis unit. Based on the proposed process design, an exergoeconomic analysis and an exergy cost distribution diagram are presented, from which the production cost of a product over each functional block of the process can be easily obtained. Analysis results show that the largest exergy loss occurs in an exothermic reformer, accounting 60.4 percent of the total exergy loss. The exergy cost distribution diagram indicates that DMC has the highest exergy cost, followed by DME and methanol, and it is economically favorable to use the exhaust gas from the chemical synthesis block for power generation.

Study on Several Versions of Dimethyl Ether Production for Resolving the Natural Gas Utilization Problem in China

Study On Systems Based On Coal And Natural Gas For Producing Dimethyl Ether

Design and analysis of a new DME production process with power cogeneration

Technical and Economic Analysis of Some Dimethyl Ether Production Technologies

Design and Analysis of a New Dimethyl Ether- Electric Power Polygeneration System

Syngas-based DME and Hydrogen Production Systems:An Option in China's Energy Technology Strategy

Study on co-feed and co-production system based on coal and natural gas for producing DME and electricity

Power to Gas: an Option for 2060 High Penetration Rate of Renewable Energy Scenario of China

PROCESS SIMULATION AND 3E ASSESSMENT OF THREE DIMETHYL ETHER PRODUCTION SYSTEMS IN CHINA

DME A Solution for Energy Security and Environmental Protectionin China

Thermodynamic Optimization of Dimethyl Ether Synthesis from Syngas in Polygeneration Systems

Research on the Integration of a Natural Gas-Distributed Energy System into the Oilfield Facility in China

Dimethyl Ether As Alternative Fuel for CI Engine and Vehicle

Biomass to Dimethyl Ether by Gasification/synthesis Technology—an Alternative Biofuel Production Route

Advance in Manufacturing Technology of Dimethyl Ether

Life cycle water footprint and carbon footprint analysis of coal gasification to clean fuel dimethyl ether

A dual-gas sourced integrated methanol/DME/DMC catalysis approach to polygeneration energy systems design and an exergoeconomic analysis

REVIEW OF DIMETHYL ETHER RESEARCHES IN CHINA

How to make the production of Methanol/DME "GREENER"-The integration of wind power with coal chemical industry

Productive Technology and Development of Down Stream Products of Dimethyl Ether

Modeling and Simulation of Production Process on Dimethyl Ether Synthesized from Coal-based Syngas by One-step Method