Abstract:A discrete element method (DEM) model is developed to simulate the dynamics of wet, flexible fibers. The angles of repose of dry and wet fibers are simulated, and the simulation results are in good agreement with experimental results, validating the wet, flexible fiber model. To study wet fiber flow behavior, the model is used to simulate shear flows of wet fibers in a periodic domain under Lees-Edwards boundary conditions. Significant agglomeration is observed in dilute shear flows of wet fibers. The size of the largest agglomerate in the flow is found to depend on a Bond number, which is proportional to liquid surface tension and inversely proportional to the square of the shear strain rate. This Bond number reflects the relative importance of the liquid-bridge force to the particle's inertial force, with a larger Bond number leading to a larger agglomerate. As the fiber aspect ratio (AR) increases, the size of the largest agglomerate increases, while the coordination number in the largest agglomerate initially decreases and then increases when the AR is greater than four. A larger agglomerate with a larger coordination number is more likely to form for more flexible fibers with a smaller bond elastic modulus due to better connectivity between the more flexible fibers. Liquid viscous force resists pulling of liquid bridges and separation of contacting fibers, and therefore it facilitates larger agglomerate formation. The effect of liquid viscous force is more significant at larger shear strain rates. The solid-phase shear stress is increased due to the presence of liquid bridges in moderately dense flows. As the solid volume fraction increases, the effect of fiber-fiber friction coefficient increases sharply. When the solid volume fraction approaches the maximum packing density, the fiber-fiber friction coefficient can be a more dominant factor than the liquid bridge force in determining the solid-phase shear stress.

Simulation of Dynamic Processes on Flexible Filamentous Particles in the Transverse Section of A Rotary Dryer and Its Comparison with Ideo-Imaging Experiments

Numerical Simulation on Mixing Dynamics of Flexible Filamentous Particles in the Transverse Section of a Rotary Drum

Simulation of Biomass Pyrolysis in a Rotary Drum by Coupling CFD-DEM with a One-Dimensional Thermally Thick Model

Simulation of dynamic transport of flexible ribbon particles in a rotary dryer

Numerical Simulation on Mixing Kinetics of Slender Particles in a Rotary Dryer

Modeling and simulation of drying characteristics on flexible filamentous particles in rotary dryers

Experimental study on the space time of flexible filamentous particles in a rotary dryer

An Investigation of Heat Transfer of Flexible Fibers in a Rotating Drum Dryer Using the Discrete Element Method

On the Applicability of the Coarse Grained Coupled CFD-DEM Model to Predict the Heat Transfer During the Fluidized Bed Drying of Pharmaceutical Granules

Three Dimensional Numerical Simulation of Mixing Process of Particles in Rotary Dryer

Numerical simulation on distribution characteristics of flexible filamentous particles in a fluidized bed dryer

Simulation Investigation of Drying Characteristics of Wet Filamentous Biomass Particles in a Rotary Kiln

Study on heat and mass transfer of flexible filamentous particles in a rotary dryer

Three dimensional numerical simulation of mixing characteristics of slender particles in rotary dryer

Heat and mass transfer characteristics of filamentous particles in transverse section of rotary dryer

Experimental study and numerical simulation on motion characteristics of granular particles in rotary dryer

Discrete Element Simulations of Flexible Ribbon-Like Particles

Discrete element simulation studies of angles of repose and shear flow of wet, flexible fibers.

Modeling and Simulation of a Co-current Rotary Dryer

DEM investigation of the axial dispersion behavior of a binary mixture in the rotating drum

Three-dimensional Simulation of Gas-Solid Flow in a Fluidised Bed with Flexible Ribbon Particles