Abstract:In the present paper, to fabricate electroluminescent devices CdSe QDs were used as active materials, TPD (N,N'-biphenyl-N,N'-bis-(3-methylphenyl)-1,1'-biphenyl-4,4'-diamine) was used as a hole transport layer, and ZnS was used as an electron transport layer. The electroluminescent properties of the organic/inorganic composite ITO/TPD/CdSe QDs/ZnS/Ag light emitting devices were studied. Both TPD and CdSe QDs thin films were spin-coated and ZnS thin films were deposited by magnetron sputtering. The surfaces of the devices are smooth. The luminescence (EL) peak of the CdSe QDs is at 580 nm which is assigned to the band-edge exciton emission. Compared to the previous EL device of ITO/ZnS/CdSe QDs/ZnS/Ag, it is seen that the new devices do not display surface state related emission peaks and EL intensity is about 10 folds that of the previous device. The enhancement of luminescence efficiency is attributed to both of the excitation of CdSe QDs by accelerated electron collision and carriers injection into QDs: (1) electrons are accelerated by the ZnS layer and collide with CdSe QDs, which excites electrons in QDs to excited states and allows them to emit photons; (2) the holes injected into QDs recombine with some of electrons excited in the QDs. The authors further studied the influence of thickness variation of ZnS on the luminescent properties. ZnS thin films are of 80, 120, and 160 nm thickness, respectively. It was found that as the thickness of ZnS increases the threshold voltage rises and EL intensity increases, but breakdown voltage decreases. The EL peak position blue shifts when the thickness of ZnS decreases. The explanation of underlying mechanism is given.

The Influence of Thickness of Luminescent Layer on Organic EL Properties

Study of Organic Electrolumenescent Thin Film Cell

Structure and electroluminescence characteristics of organic thin film electroluminescent devices

Study on the mechanism of organic thin film electroluminescence

Analysis on Mechanism of Current Transport in Organic Electroluminescent Thin Film Device

The Review and Development of Organic Thin Film Electroluminescene

Analysis of the Effect of Active Layer Thickness on Polymer Solar Cell Performance Based on Optical and Opto-Electronic Model

Determination of optical constants and thickness of photoactive layer in polymer oslar cells by single transmission measurement

Effect of Film Thickness on Properties of Al-Doped Zno Film As Transparent Conducting Electrodes in Oleds

Investigating the Effect of the Conductivity of the Electron Transportation Layer on the Organic Light-Emitting Diodes

Influence of Different Hole Transport Layer on the Performance of Organic Light-Emitting Devices

Studies on the Performances of Blue Organic Electroluminescent Device with Different Electron Transport Layers

Influence of the Energy Level Matching on the Performances of Organic/Polymeric Electroluminescent Devices

[Influence of Parameters of ZnS Film on the Organic/inorganic Composite Luminescence Devices].

Study on ITO/Ag/ITO multilayer film as the electrode of organic light-emitting diodes

Experimental Study of Low-Voltage -Driven Thin Film Electroluminescence Mechanism

Dependence of the Performance of the Organic Electroluminescent Devices Upon the Deposition Rate of Organic Thin Films

Studies on organic electroluminescent thin film devices

Enhancement of Electron Injection in Organic Light-Emitting Devices Using an Ag/LiF Cathode

Influence of the hole transport layer on the performance of organic light-emitting diodes

The colour-tuning effect of 2,9-dimethyl-4,7-diphenyl-1, 10-phenanthroline in blue–red organic light-emitting devices