Abstract:Advanced intermetallic beta-solidifying gamma-TiAl-based alloys have various potential applications in the aerospace and automobile industries due to their low density, functionality at higher temperatures, and high specific strength/modulus. The crucial aspect that needs to be considered when developing a new beta-solidifying gamma-TiAl alloy is to clarify the influence law of beta-stabilizer elements on the phase transformation behavior of gamma-TiAl alloys. In this work, the impact of W contents (0.5%-1.0%, atomic fraction) on the phase transformation behavior and microstructure characteristics of Ti-42Al-5Mn-xW (atomic fraction) alloy with low cost and superior temperature workability was systematically investigated. The findings demonstrate that there were minor changes in the beta-phase single region temperature (T-beta) and gamma phase solvus temperature (T gamma-solv); furthermore, the eutectoid reaction temperature (T-eut) increases with the W content from 0.5% to 1.0%. Addition of W influences the solid phase transformation pathway to a certain extent. When the concentration of W increases to 0.5%, the equilibrium phase of the alloy at near service temperature gradually changes from alpha(2) + gamma + Laves to beta(o) + alpha(2) + gamma + Laves. Additionally, W addition will also have a substantial effect on the lamellar microstructure. The volume fraction of lamellar microstructure considerably decreased after alloying with (0.5%-1.0%)W for Ti-42Al-5Mn alloy when being treated in the (gamma + alpha + beta) triple-phase region followed by furnace cooling. Increasing the W content to 0.8% and 1.0% results in the development of gamma and beta(o) grain phases with almost complete removal of alpha(2)/gamma lamellar structures. However, the W-free and W-bearing Ti-42Al-5Mn alloys show near complete lamellar structures when treated in (alpha + beta) two-phase region followed by furnace cooling. Furthermore, when the content of W increased from 0.5% to 1.0%, an equiaxed grain structure with refined lamellar colonies is typically obtained.

B2 precipitates and distribution of W in a Ti–47Al–2W–0.5Si alloy

High-Resolution and Analytic Electron Microscopy Investigations on the Microstructure of A Tial (W, Si) Alloy

The W alloying effect on thermal stability and hardening of nanostructured Cu-W alloyed thin films

Effect of Nb and B on the Precipitation Behaviors in Al-Ti-Nb Balanced Ratio Ni-Based Superalloy: A Phase-Field Study

On the Orientation Relationship Between Ti5Si3 Precipitates and B2 Phase in a Ti-47Al-2W-0.5Si Alloy

Effects of W on the Unidirectional Solidification Structures of TiAl Based Alloy

Interface and precipitate investigation of a TiB2 particle reinforced NiAl in-situ composite

B2 phase precipitation behavior in Ti–40Al–8Nb alloys during the hot deformation process

On the Orientation Relationship Between A2precipitates and the B2 Phase in a Ti-47at.%Al-2at.%W-0.5at.%Si Alloy

Effect Of W On Structural Stability Of Tial Intermetallics And The Site Preference Of W

The α2 precipitation from equiaxed γ phase in as-cast Ti-44Al-4Nb-2Cr-0.1B alloy

Boride Formation, Microstructure Evolution, and Mechanical Properties of Ti42Al6Nb2.6C0.8Ta Alloyed by Boron

Revealing the B addition on tribology performance in TiZrHfTa0.5 refractory high-entropy alloy at ambient and elevated temperature

Insights into the Role of W/B Alloying on High-Temperature Oxidation Behavior of Ti42Al5Mn Alloy

Microstructure Evolution and Mechanical Properties of Ultra-Fine Grain AlCrFe2Ni2Wx High-Entropy Alloys

Segregation of alloying elements in a fully lamellar TiAl alloy

Effect of W Content on the Phase Transformation Behavior in Ti-42Al-5Mn-<i>x</i>W Alloy

Atomic-scale investigation of the interface precipitation in a TiB2 nanoparticles reinforced Al–Zn–Mg–Cu matrix composite

Coherent precipitation and stability of cuboidal nanoparticles in body-centered-cubic Al0.4Nb0.5Ta0.5TiZr0.8 refractory high entropy alloy

B2-precipitation induced optimization of grain boundary character distribution in an Al0.3CoCrFeNi high-entropy alloy

Microstructure Evolution of Ti–46Al–6Nb–（Si,B） Alloys During Heat Treatment with W Addition