Abstract:Hydroformed tubular parts have been widely used in a variety of applications requiring high strength and high dimensional accuracy. However, the essence and strategy for controlling dimensional accuracy of the parts have not been given an in-depth investigation. In this paper, a strategy for compensating the springback of hydroformed tubular parts is proposed to improve their dimensional accuracy. It is believed that the parts have the highest dimensional accuracy when the expansion amount of die cavity is exactly equal to the springback of tubular part by controlling the internal pressure. The theoretical calculation formula of target pressure is firstly derived under the assumption of axisymmetric plane strain without considering the influence of clamping force. The proposed control strategy was then implemented experimentally to validate its feasibility. It is shown that the diameters of SAPH440 tubular parts increase linearly with increasing internal pressure from 60 to 240 MPa. After unloading and removing the tubular parts from die cavity, a certain springback will occur on the parts. When the internal pressure reaches the target pressure of 150 MPa, the diameter of final part is exactly equal to the target value. Moreover, due to the inevitable effect of clamping force in experiments, the target pressure in the experiment is lower than that from theoretical prediction. Finally, it is further proved by repeated experiments that the diameter deviation of tubular parts can be controlled accurately within range of [-0.05 mm, + 0.05 mm]. These results provide theoretical basis and technical support for precision manufacturing of key components for automobile and aerospace.

Improving dimensional accuracy of a u-shaped part through an orthogonal design experiment

Eliminating Springback Error in U-Shaped Part Forming by Variable Blankholder Force

Parameters Optimization of Tailor Welded Blank Forming Process

Data-driven accurate design of variable blank holder force in sheet forming under interval uncertainty using sequential approximate multi-objective optimization.

Multi-Objective Optimization of Dimensional Accuracy in Electric Hot Incremental Sheet Forming

The Optimization of Variable Blank-Holder Forces Based on Numerical Simulation

Novel algorithm for determining optimal blankholder forces in deep drawing of aluminum alloy sheet

Numerical Simulation-Driven Optimization Of. Sheet Metal Drawing Part Shape

Numerical multi-objective optimization of segmented and variable blank holder force trajectories in deep drawing based on DNN-GA-MCS strategy

The Numerical Simulation of U-channel Springback and Optimization of Forming Parameters

Springback Behavior and Control Strategy for Dimensional Accuracy of Hydroformed Tubular Parts

Study on the Forming Process Parameters of Automobile Front Panel Reinforcing Plate Using Orthogonal Experiment Method by Numerical Simulation Technology

Optimization of Process Parameters in Deep Drawing Process Based on Orthogonal Experiment Method

A New Strategy to Optimize Variable Blank Holder Force Towards Improving the Forming Limits of Aluminum Sheet Metal Forming

Optimization of Geometrical Design of Clinching Tools in Clinching Process with Extensible Dies

A New Approach of Die Shape Optimization for Sheet Metal Forming Processes

Numerical Optimization of Variable Blank Holder Force Trajectories in Stamping Process for Multi-Defect Reduction

Modelling and prediction of twist springback for UHSS thin-walled component with asymmetric complex section in roll forming process

A Compensation Algorithm of Springback Error in Complex 3D Sheet Metal Forming and Experiment Validation

Numerical and Physics Simulations of Variable Blank Holder Force in Process of Deep Drawing Complex Overlay

OPTIMIZATION DESIGN VARIABLE BLANKHOLDER FORCE IN SHEET METAL FORMING