Abstract:In this study, the cooperative effect of Mg and Si contents on the microstructural evolution, mechanical properties, and deformation behavior of the cast Al–Li–Mg–Si alloys is investigated. Five different Al–Li–Mg–Si alloys are prepared by conventional casting method, which are referred to as Alloy A-E. The results show that with the increase in the Mg content, the amount of lath-like Mg2Si precipitates and bulk-like AlLiSi particles increases, which leads to an improvement in the strength and ductility of alloys. The amount of intergranular Si-rich phases in Alloy D increases with the increase in the Si content. Further, a higher Si content in Alloy E promotes the formation of bulk-like AlLiSi. The geometric phase analysis (GPA) results reveal strain partitioning behavior at the interface of Mg2Si precipitates and AlLiSi particles, which follows the Orowan looping or dislocation cutting strengthening mechanism. The geometrically necessary dislocation (GND) density calculation results suggest that the lath-like Mg2Si precipitates play a critical role in the deformation behaviors of Alloy A-C. The hindering effect of lath-like Mg2Si precipitates on the movement of dislocations decreases the GND density gap between high-angle grain boundaries or junctions and grain interior and improves the resistance to deformation. However, the deformation behaviors of Alloy D and E with higher Si content are mainly governed by the intergranular Si-rich phases. Finally, a methodological framework is established to elucidate the effect of precipitates and/or intergranular phases on the deformation behaviors of materials using a combination of GPA and GND density calculation methods.

Influences of Morphology and Size of Mg2Si on Microstructural Evolution of Mg–6.2Si Alloys During Partial Remelting

The Effect of Solution Treatment on the Si Particles’ Morphology Evolution and the Thermal Conductivity and Tensile Properties of Sb-Modified Al-8Si-0.6Mg Alloys

Modification of Primary Mg2si in Mg-4si Alloys with Antimony

Effect of Microstructure on the Precipitation of β-Mg2Si during Cooling after Homogenisation of Al-Mg-Si Alloys

Microstructure Evolution and Properties of Mg-9Gd-0.8Al Alloy with Lamellar Phase During Extrusion at Different Temperatures

Regulative Effect of Mg/Si Ratio on Microstructure Evolution and Mechanical Properties of Cast Al-Li-Mg-Si Alloys

The Effect of Multidirectional Forging on the Microstructure and Superplasticity of the Al–Mg–Si–Cu System Alloys with Different Contents of Mg and Si

Effect of Pour Mode and Cooling Rate on Morphologies of Mg2Si in AZ91-0.45Si Magnesium Alloy

Relationship between Microstructure Evolution and Tensile Properties of AlSi10Mg Alloys with Varying Mg Content and Solidification Cooling Rates

Microstructure Evolution in Undercooled Ni-Si Melt

Effect of Strontium and SmO on the Microstructure and Fracture Mode of AlSi-Mg2Si Brazing Filler Metal

Influence of Li2sb Additions on Microstructure and Mechanical Properties of Al-20mg(2)Si Alloy

Heterogeneous Nucleation of Mg2Si on Sr11Sb10 Nucleus in Mg–x(3.5, 5 Wt.%)si–1al Alloys

Effects of Si Content and Modification on Microstructure and Properties of In-situ Mg2Si/Mg Composites

Microstructure evolution of semi-solid billet fabricated by semi-solid isothermal heat treatment of wrought AlSi7Mg aluminum alloy

Effect of Extrusion Temperature on Microstructural Evolution and Intergranule Bonding of Al–7Si–0.3Mg (wt%) Alloy Rods Produced by Extrusion of Granule Compacts

The Effect of Mn on the Microstructure of Spray-Deposited Al–20Si–5Fe–3Cu–1Mg Alloy

Cooperative Effect of Mg and Si Contents on the Microstructural Evolution, Mechanical Performance, and Deformation Behavior of Cast Al–Li–Mg–Si Alloys

Microstructural Evolution of Al-Si Alloy above Liquidus Temperature during Holding Temperature

Dendritic Si growth morphologies in highly undercooled Al-Si alloys

Effect of melt overheating, cooling and solidification rates on Al–16wt.%Si alloy structure