Abstract:In view of its high precision and high efficiency, three-dimensional digital image correlation (3D-DIC) is widely used to accurately measure full-field deformation. A spatiotemporal experimental study using 3D-DIC to explore the Portevin–Le Chatelier (PLC) deformational behavior, provides a new insight into the whole 3D deformation field, including the out-of-plane displacement, and in particular the relationship between the serrations and the strain field in the deformation bands corresponding to individual serrations. Specimens 1, 2 and 3 mm thick of 5456 Al-based alloy were tested in uniaxial tension at room temperature at strain rates from 1.8 × 10 −4 to 9.1 × 10 −3 s −1 . The spatial and temporal characteristics of the strain localization were quantitatively analyzed. The out-of-plane displacement increment field ( w ) of the localized bands was observed by 3D-DIC, and found to be related to the specimen thickness and the in-plane strain increment. The largest displacement increments were respectively 15, 10 and 5 μ m for 3, 2 and 1 mm specimens at maximum strain increment of about 12000 μ ε . The elastic shrinkage outside the deformation bands was found to be an essential characteristic of the PLC effect. The width of the PLC band ( w b a n d ) increased with increasing thickness; the angle of the PLC band ( 𝜃 b a n d ) was not affected by either specimen thickness or serration amplitude. Temporally, the serrations in the plots both of in-plane strain and out-of-plane displacement vs. time coincided throughout the entire loading procedure. When PLC banding occurred, the serration amplitude within the bands was found to be proportional to the maximum strain increment in the direction of the applied tensile force ( 𝜖 m a x ).

Time-resolved deformation measurements of the Portevin–Le Chatelier bands

On the Propagation and Pulsation of Portevin-Le Chatelier Deformation Bands: an Experimental Study with Digital Speckle Pattern Metrology

Deformation Measurements of Three Types of Portevin–Le Chatelier Bands

OS12-2-2 Time-resolved Deformation Measurements of the PLC Shearing Bands

Investigation of Kinematics of the Portevin-Le-Chatelier Deformation Bands with Dynamic Digital Speckle Pattern Interferometry

A simple method enabling efficient quantitative analysis of the Portevin–Le Chatelier band characteristics

Investigation on the Nucleation of PLC Shearing Deformation Band with High-Speed DSPI Method

Spatial characteristics of the Portevin-Le Chatelier deformation bands in Al-4 at%Cu polycrystals

Digital Shearography Investigation on the Out-Plane Deformation of the Portevin-Le Chatelier Bands

The Portevin-Le Chatelier Effect in Al-Mg Alloy Investigated by Infrared Pyrometry

Investigation on the Portevin-Le Chatelier Deformation Bands in Al-Cu Alloys

Propagation characteristics of portevin-Le chatelier bands

Study of Propagation and Pulsation of Slip Band Using Dynamic Digital Speckle Pattern Interferometry

Investigation of Portevin-Le Chatelier Band with Temporal Phase Analysis of Speckle Interferometry

Effect of Strain Rate on Spatio-Temporal Behavior of Portevin–Le Châtelier Bands in a Twinning Induced Plasticity Steel

White-Light Digital Speckle Image Correlation Analysis of the Portevin-Le Chatelier Shearing Band in Multiscale

Deformation Measurements of Serrated Yielding Shear Bands in Al-4%Cu Alloy

Experimental Study on Three-Dimensional Deformation Field of Portevin–Le Chatelier Effect Using Digital Image Correlation

Investigation of Propagation and Pulsation of Slip Band Using Dynamic Dspi

On the spatio-temporal characteristics of the Portevin-Le Chatelier effect in aluminium alloy AA5182: An experimental and numerical study

Experimental investigations on kinetics of Portevin–Le Chatelier effect in Al–4wt.%Cu alloys