Abstract:The Protein-Le Chatelier (PLC) effects are investigated by using digital image correlation at a constant applied strain rate of 5.0010-3 s-1 and room temperature in Al-Mg alloys with Mg content values (wt.%) of 2.30, 4.57, 6.10 and 6.91 respectively in this study. Both the yield strength and the ultimate strength increase with increasing Mg content, which is generally called solution strengthening. Type of PLC band changes from A to B with increasing Mg content. In low Mg content (2.30%) alloy, the serration amplitude almost remains 1 MPa, while in each of high Mg content (4.57%, 6.10%, 6.91%) alloys it linearly increases with the strain increasing. The serration amplitude is found to increase with increasing Mg content and gradually reaches a saturated state. With the increase of Mg content, the period of PLC band for continuous propagation gradually reduces and the time when the PLC band location sudden jumps increases in the process of propagation. When the strain is small, the out-of-band deformation of alloy is inhomogeneous obviously. And the deformation inhomogeneity slightly decreases with increasing Mg content. DIC results indicate that the PLC bandwidth does not change with Mg content, while the maximum strain increment in the PLC band increases with increasing both Mg content and strain. Additionally, special periodic damped serrations are observed in the stress-time curve of the low Mg content (2.30%), the corresponding PLC band shows that the periodic changed serrations in the stress-time curve correspond to the transformation of the PLC band orientation. Besides, the PLC band propagates upward continuously both before and after the shift.

Investigation on the Portevin-Le Chatelier Deformation Bands in Al-Cu Alloys

On the Propagation and Pulsation of Portevin-Le Chatelier Deformation Bands: an Experimental Study with Digital Speckle Pattern Metrology

The Portevin-Le Chatelier Effect in Al-Mg Alloy Investigated by Infrared Pyrometry

Investigation of Kinematics of the Portevin-Le-Chatelier Deformation Bands with Dynamic Digital Speckle Pattern Interferometry

Spatial characteristics of the Portevin-Le Chatelier deformation bands in Al-4 at%Cu polycrystals

Experimental investigations on kinetics of Portevin–Le Chatelier effect in Al–4wt.%Cu alloys

Deformation Measurements of Serrated Yielding Shear Bands in Al-4%Cu Alloy

The Effect of Solution Treatment on the Spatial Behavior of the Portevin-Le Chatelier Effect in Al-Cu Alloys

Deformation Measurements of Three Types of Portevin–Le Chatelier Bands

Thermal Analyses and Simulations of the Type A and Type B Portevin–Le Chatelier Effects in an Al–Mg Alloy

White-Light Digital Speckle Image Correlation Analysis of the Portevin-Le Chatelier Shearing Band in Multiscale

Characterization of the deformation behaviors associated with the serrated flow of a 5456 Al-based alloy using two orthogonal digital image correlation systems

Time-resolved deformation measurements of the Portevin–Le Chatelier bands

On the spatio-temporal characteristics of the Portevin-Le Chatelier effect in aluminium alloy AA5182: An experimental and numerical study

Investigation of Portevin–Le Chatelier Band Strain and Elastic Shrinkage in Al-Based Alloys Associated with Mg Contents

Experimental Investigation on the Influence of Mg Content on Portevin-Le Chatelier Effect in Al-Based Alloys by Using Digital Image Correlation

Digital Shearography Investigation on the Out-Plane Deformation of the Portevin-Le Chatelier Bands

Investigation on the Nucleation of PLC Shearing Deformation Band with High-Speed DSPI Method

Characterization of Portevin–Le Chatelier Effect in Aluminum Alloy AA5052 under Strain-Controlled Tensile Test Via Digital Image Correlation and Acoustic Emission

Study of Propagation and Pulsation of Slip Band Using Dynamic Digital Speckle Pattern Interferometry

Propagation characteristics of portevin-Le chatelier bands