Abstract:The group-Ⅲ nitrides and their related ternary alloys have been becoming the most attractive material for light emitting diodes (LEDs) and laser diodes (LDs) in the UV and blue spectral range. However, the origins of the yellow luminescence (YL), which is commonly observed in almost undoped and n-type GaN, remain unclear. The nature and the role of initial nitridation of sapphire surface and the generation of threading dislocation (TD) are ambiguous too. It is a possible way to resolve the above problems by studying the microstructures and optical properties combining the growth conditions. In this work, two kinds of GaN films were grown by MOCVD under different initial nitridation time (180 seconds for Sample A, and 90s for Sample B). The growth temperature is about 950℃. The cross-sectional transmission electron microscope (TEM) is performed near the GaN/sapphire interface. Corresponding the growth processes, there are three zones in the GaN layer: buffer layer, zone and sound zone. There are haystack-like domains in the faulted zone, in which there are high density of extended defects. The thickness of the faulted zone is about 0.4μm. Just above this region, the defects density is reduced sharply, and the quality of the layer is improved, which is identified by electron diffraction (ED) patterns. In comparison, Sample A shows about an order lower density of extended defects than Sample B, their columnar diameter is larger and its ED pattern is sharper, too. The buffer layer of Sample B is more smooth than Sample A. The appropriate rougher morphology of the buffer layer may cause that the structural disorder between the high-temperature (HT) grown island and the buffer layer is accommodated by Frank and Shockley partial dislocations. However, the TD is likely to propagate into the HT GaN from the smooth surface of the buffer layer grown after extensively nitridation of substrate. According to the position and width of X-ray diffraction peaks of (0002) and (0004), the size of crystalline grain, D and the residual strain could be calculated. The values of(D,e in)of Sample A and B are (175nm,0.167%) and (90nm,0.141%), respectively. Small size of crystalline grain may be advantageous to relieve the lattice and thermal mismatch stress, but it lead to higher density of extended defects. The width of GaN (0002) reflections of Sample A is 4min lower than that of Sample B. This result may be due to the lower screw TD. The higher density of screw TD may widen the GaN (0002) peak in X-ray rocking curve. In room temperature PL spectra, the ratio of band-edge emission intensity to YL one of Sample A is 3 orders larger than that of Sample B. Furthermore the YL in Sample B is stronger and has fine structure, while that in Sample A is nearly invisible in the PL spectrum. The GaN epilayer with high quality exhibits almost no YL emission. It is well known that the YL corresponds to the deformed crystal structure. We assigned that the screw TD and mixed TD are attributed to the YL referring to our XRD results.

Effect of SiO2(1.2 Μm)/ti-Foil Substrate Nitridation on GaN Thin Films Grown by Reactive Evaporation Method

The Effects of Substrate Nitridation on the Growth of Nonpolar A-Plane GaN on R-Plane Sapphire by Metalorganic Chemical Vapor Deposition

Nitridation Effect of the Α-Al2o3 Substrates on the Quality of the GaN Films Grown by Pulsed Laser Deposition

Influence of Ga Concentration in Si Substrates on the Quality of GaN Films

The Effects of Sapphire Nitridation on GaN Growth by Metalorganic Chemical Vapour Deposition

GaN films synthesized through reactively reconstructing Ga_2O_3 films sputtered on Ga-diffused Si substrates

Effect of Nitridation on GaN Film Grown on Glass Substrate by ECR-PEMOCVD Method

N-polar GaN Film Epitaxy on Sapphire Substrate without Intentional Nitridation

Study on the Nitridation of Β-Ga2o3 Films*

The Effect of Nitridation on Sputtering AlN on Composited Patterned Sapphire Substrate

X-ray Diffraction, Photoluminescence and Secondary Ion Mass Spectroscopy Study of GaN Films Grown on Si(111) Substrate by Vacuum Reactive Evaporation

Enhancement of optical property and crystal structure for GaN films on 2D MoS2 buffer layer by nitridation treatment

Effects of GaAs Substrate Nitridation with N2-H2 Plasma on c-GaN Epitaxy Growth by ECR-PEMOCVD

Study of Nitridation Effect on Structural, Morphological, and Optical Properties of GaAs Film Growth on Silicon Substrates via Close Space Vapor Transport Technique

Electron Microscope Analysis of the Quality of GaN Films Deposited on Ga-diffused Si (1 1 1) Substrates

Investigation of GaN layer grown on Si(1 1 1) substrate using an ultrathin AlN wetting layer

Influences of SiNx Interlayer on the Crystalline Quality and the Surface Morphology of GaN Epitaxial Films

Effect of initial condition on the quality of GaN film and AlGaN/GaN heterojunction grown on flat sapphire substrate with ex-situ sputtered AlN by MOCVD

Two-dimensional X-ray diffraction and transmission electron microscopy study on the effect of magnetron sputtering atmosphere on GaN/SiC interface and gallium nitride thin film crystal structure

Microstructural and Optical Properties of GaN Films on Nitrided Sapphire Substrates

Growth of High Quality N-polar N-Gan on Vicinal C-face N-Sic Substrates for Vertical Conducting Devices