Abstract:Based on the model of long-distance and large-capacity UHVAC line with double-end source, two different methods are used to limit overvoltage and the economical evaluation of the two methods are given. One of them is increasing the number of average subsections of transmission line, namely the overvoltage is limited by only adopting metal oxide arrester (MOA) and HV shunt reactor when opening and closing resistors are not used, and the another one is to limit load-rejection opening overvoltage by adding opening and closing resistors to circuit breakers. Simulation results show that the maximum difference of opening overvoltage levels by the two limiting measures is about 0.04 p.u., so the effects of limiting overvoltage by the two methods are basically the same. Through the measure of increasing subsection number of transmission line the load-rejection opening overvoltage under single-phase earth fault can be limited, however the number of required switching stations is more, so the investment cost is high;through adding opening and closing resistors the same purpose of effectively limiting the overvoltage by lesser subsection number of transmission line can be achieved, meanwhile the number of switching stations can be reduced due to decreasing of the number of subsections of transmission line, so hundreds of millions RMB can be saved, and even the highest saved investment cost may be up to 1 billion RMB. Study results also show that the best value of opening resistor is within the range from 600Ωto 700Ω, thus to limit load-rejection overvoltage it is suitable for long-distance and large-capacity transmission lines to add opening and closing resistors.

Limiting the Arc Over-voltage of 10kV Grids in Application of Nonlinear Resistance

Research on Lightning Protection of 220kv Substation with Long Cable Inlet Wire

Research of neutral grounding modes for 20kV distribution network

Neutral-Point Voltage Regulation and Control Strategy for Hybrid Grounding System Combining Power Module and Low Resistance in 10 kV Distribution Network

Research of Neutral Grounding Modes for 20 Kv Distribution Network

Study on simulation of ferroresonance elimination in 10kV power system

Research on lightning intruding waves in 220 kV GIS substation

Research on Neutral Point Grounding via Resistance for 66 kV Distribution Network

An Active Voltage-Type Grounding Fault Protection Method for Medium-Voltage Distribution Networks with Neutral Point Voltage Flexible Regulation

Study on Neutral-Bus Overvoltage Mechanism of ±500 Kv DC Power Transmission Project from Tianshengqiao to Guangdong

Investigation on test schemes for grounding grids corrosion diagnosis

Ferro-resonance Over-Voltage and Power Frequency Over-Voltage on the Neutrals of 220kv Power Transformer and Corresponding Protection Strategy

Study on High Impedance Grounding Fault Protection for Personal Safety Guard in Distribution Grid

Restriction on Secondary Arc Current on Ultra-high Voltage AC Double Circuit Transmission Lines on the Same Tower

Research on Hangzhou 10 Kv Distribution Network Closing Loop Operation

Analysis on Overvoltage in Renovated Control and Protection System for HVDC Power Transmission Project from Tianshengqiao to Guangzhou

Discussion about 20 kV System Client Substation Design

Nonlinear Modeling Analysis and Arc High-Impedance Faults Detection in Active Distribution Networks With Neutral Grounding via Petersen Coil

A Calculation Method Of Analytical Dc Fault Current In Mmc-Hvdc Grid Including Current-Limiting Devices

Comparative Study on Measures to Limit Load-Rejection Opening Overvoltage of Long-Distance and Large-Capacity UHVAC Transmission Lines

Analysis of Application of 500 kV Transformer with Low Reactance Grounding