Abstract:In order to predict VFTO (very fast transient overvoltage) distributions in the windings during transformer design stage, it is important to acquire the frequency range of the surge wave that could enter the transformer winding, and then model the windings in that frequency range. In GIS (gas insulated station), transformer is connected to bus through bushing and lead wire. The bushing capacitance to ground will bypass the high frequency components, so there should be a upper limit of the frequency components of the surge wave at the entrance of the transformer. In this paper, the transformer windings are modeled using MTL (multitransmission-line) model firstly, then the lumped equivalent circuit is formulated with the -type circuits, and finally the driving-point impedance and voltage transfer functions of the equivalent circuit are calculated using nodal analysis. The driving-point impedance of a model winding is calculated and compared with the measured result, and the validation of the equivalent circuit of transformer winding in the frequency range below 20 MHz is verified. Then the driving-point impedances of two real transformer windings are calculated with the equivalent circuit. Taking the lead impedance into consideration, the impedance of the winding is compared with the one of the bushing capacitance. The results show that most of the energy of the frequency components above 10 MHz in the surge wave will pass through the bushing capacitance and will not cause damage to transformer insulations.

Macroscopic Broadband Loss Characteristics of Power Transformer Winding Extracted by Vector Fitting Method

Determining the Broadband Loss Characteristics of Power Transformer Based on Measured Transformer Network Functions and Vector Fitting Method

Simplified Analytical Model and Investigation of Open-Circuit AC Winding Loss of Permanent-Magnet Machines.

Study on Broadband Loss Characteristics of Oil-Immersed Papers for Fast Transient Modeling of Power Transformer

Investigation on broadband characteristics of losses in power transformer interturn insulation paper by dielectric relaxation model

Research on Short-Circuit Vibration of Power Transformer

Experimental Characterization of Hybrid Temperature and Frequency Effects on the Performance of Transformers on Silicon Substrate

Calculation Method of Winding Eddy-Current Losses for High-Voltage Direct Current Converter Transformers

Research on Transient Electric Field Distribution of High-Frequency Transformers Based on COMSOL and SIMULINK Co-simulation

Simulation and Analysis of Electromagnetic Properties at the Secondary Port of Electronic Current Transformers Under Very Fast Transient Overvoltage

Evaluation of the Calculation Method for Stray Losses in Structural Parts of HVDC Converter Transformers

Piecewise Frequency-domain Modeling of Large Power Transformer Windings for Very Fast Transient Overvoltage Simulations

In-Situ Measurement and Investigation of Winding Loss in High-Frequency Cored Transformers Under Large-Signal Condition

Broadband Port Circuit Model for Distribution Transformers Based on Frequency Impedance Analysis

A Simple Power Loss Evaluation Method for High-Frequency Transformers Based on Surface Temperature Measurement Within Wide Operation Range

A Circuit Model in a Wide Frequency Range for Power Transformer and Analysis of Its Characteristics

Modeling and Simulation of Wide-Frequency Characteristics of Electromagnetic Standard Voltage Transformer

Broadband Equivalent Circuit Modeling for Medium Voltage High-Frequency Transformers with Multi-Shielding Structure

Dynamic Electromagnetic Force Analysis of a Power Transformer with Regulated Windings

Calculation of Fast Transient Voltage Distributions in Transformer Windings Using Generalized Eigenvalue Method

An Improved Winding Loss Analytical Model of Flyback Transformer