Abstract:In order to predict VFTO (very fast transient overvoltage) distributions in the windings during transformer design stage, it is important to acquire the frequency range of the surge wave that could enter the transformer winding, and then model the windings in that frequency range. In GIS (gas insulated station), transformer is connected to bus through bushing and lead wire. The bushing capacitance to ground will bypass the high frequency components, so there should be a upper limit of the frequency components of the surge wave at the entrance of the transformer. In this paper, the transformer windings are modeled using MTL (multitransmission-line) model firstly, then the lumped equivalent circuit is formulated with the -type circuits, and finally the driving-point impedance and voltage transfer functions of the equivalent circuit are calculated using nodal analysis. The driving-point impedance of a model winding is calculated and compared with the measured result, and the validation of the equivalent circuit of transformer winding in the frequency range below 20 MHz is verified. Then the driving-point impedances of two real transformer windings are calculated with the equivalent circuit. Taking the lead impedance into consideration, the impedance of the winding is compared with the one of the bushing capacitance. The results show that most of the energy of the frequency components above 10 MHz in the surge wave will pass through the bushing capacitance and will not cause damage to transformer insulations.

Calculation of Fast Transient Voltage Distributions in Transformer Windings Using Generalized Eigenvalue Method

Calculation Method of Winding Eddy-Current Losses for High-Voltage Direct Current Converter Transformers

Calculation of Very Fast Transient Overvoltage Distributions in Large Power Transformer Windings

The Numerical Simulation Method of Transformer Internal Short-Circuit Fault

A General Fast Power Flow Algorithm for Transmission and Distribution Networks

Piecewise Frequency-domain Modeling of Large Power Transformer Windings for Very Fast Transient Overvoltage Simulations

Research on Transient Electric Field Distribution of High-Frequency Transformers Based on COMSOL and SIMULINK Co-simulation

Determination of equivalent parameters of the transformer winding for transient analysis

Accurate and Efficient Computation of the Inductance Matrix of Transformer Windings for the Simulation of Very Fast Transients

Improved lumped parameter model for transformer fast transient simulations

Dynamic Electromagnetic Force Analysis of a Power Transformer with Regulated Windings

Wide Band Modeling of Large Power Transformer Windings for Very Fast Transient Overvoltage (VFTO) Analysis

FE-based equivalent circuits for simulating transformer internal faults

Calculation of the internal impedance of wire for the transient simulation in transformer windings

Calculation of Transient Voltage Distribution in Transformers Using Bergeron's Method

ANALYSIS OF ELECTROMAGNETIC FIELDS AND EDDY CURRENT LOSSES IN LARGE POWER TRANSFORMERS

A Circuit Model in a Wide Frequency Range for Power Transformer and Analysis of Its Characteristics

Voltage Distribution Analysis of High Dv/dt Fed Machines Using High Frequency Winding Model

Calculation of Parameters in Transformer Winding Based on the Model of Multi-Conductor Transmission Line

Determining the Broadband Loss Characteristics of Power Transformer Based on Measured Transformer Network Functions and Vector Fitting Method

Inter-Turn Breakdown Fault Analysis and Winding Structure Optimisation of Winding of Dry-Type Transformers in Wind Farms