Abstract:In order to predict VFTO (very fast transient overvoltage) distributions in the windings during transformer design stage, it is important to acquire the frequency range of the surge wave that could enter the transformer winding, and then model the windings in that frequency range. In GIS (gas insulated station), transformer is connected to bus through bushing and lead wire. The bushing capacitance to ground will bypass the high frequency components, so there should be a upper limit of the frequency components of the surge wave at the entrance of the transformer. In this paper, the transformer windings are modeled using MTL (multitransmission-line) model firstly, then the lumped equivalent circuit is formulated with the -type circuits, and finally the driving-point impedance and voltage transfer functions of the equivalent circuit are calculated using nodal analysis. The driving-point impedance of a model winding is calculated and compared with the measured result, and the validation of the equivalent circuit of transformer winding in the frequency range below 20 MHz is verified. Then the driving-point impedances of two real transformer windings are calculated with the equivalent circuit. Taking the lead impedance into consideration, the impedance of the winding is compared with the one of the bushing capacitance. The results show that most of the energy of the frequency components above 10 MHz in the surge wave will pass through the bushing capacitance and will not cause damage to transformer insulations.

Determining the Broadband Loss Characteristics of Power Transformer Based on Measured Transformer Network Functions and Vector Fitting Method

Macroscopic Broadband Loss Characteristics of Power Transformer Winding Extracted by Vector Fitting Method

Study on Broadband Loss Characteristics of Oil-Immersed Papers for Fast Transient Modeling of Power Transformer

Research on Transient Electric Field Distribution of High-Frequency Transformers Based on COMSOL and SIMULINK Co-simulation

Experimental Characterization of Hybrid Temperature and Frequency Effects on the Performance of Transformers on Silicon Substrate

Simulation and Analysis of Electromagnetic Properties at the Secondary Port of Electronic Current Transformers Under Very Fast Transient Overvoltage

Evaluation of the Calculation Method for Stray Losses in Structural Parts of HVDC Converter Transformers

Investigation on broadband characteristics of losses in power transformer interturn insulation paper by dielectric relaxation model

Calculation Method of Winding Eddy-Current Losses for High-Voltage Direct Current Converter Transformers

A Simple Power Loss Evaluation Method for High-Frequency Transformers Based on Surface Temperature Measurement Within Wide Operation Range

Research on Short-Circuit Vibration of Power Transformer

Piecewise Frequency-domain Modeling of Large Power Transformer Windings for Very Fast Transient Overvoltage Simulations

Modeling and Simulation of Wide-Frequency Characteristics of Electromagnetic Standard Voltage Transformer

High-Precision Simulation For Structure And Efficiency Optimization Of High-Power High-Frequency Transformer

Broadband Port Circuit Model for Distribution Transformers Based on Frequency Impedance Analysis

Detailed Losses Analysis of High-Frequency Planar Power Transformer

A practical technique to measure transformer losses in high frequency SMPS

Broadband Equivalent Circuit Modeling for Medium Voltage High-Frequency Transformers with Multi-Shielding Structure

In-Situ Measurement and Investigation of Winding Loss in High-Frequency Cored Transformers Under Large-Signal Condition

Design and Analysis of Low Frequency Transformer Applied in Fractional Frequency Transmission System

A Circuit Model in a Wide Frequency Range for Power Transformer and Analysis of Its Characteristics