Abstract:The inner temperature of power transformers is one of the major factors of the life of insulation life and the load operation mode in transformers. So it's of great significance to predict and calculate the inner temperature of transformers precisely in different loads and ambient temperature, which could be used to assess the surplus useful life and the safety performance of transformers. When the inner temperature of transformers is too low, it's evident that the load capacities of the power transformers are in half-load or less, which might reduce the economic benefit. However, when the inner temperature of transformers is too high, Not only do the ageing rating of insulation structure in power transformers is accelerated, but also the dielectric loss angle because of the aging products, which could prompt the inner temperature in power transformers higher. As a result, the remaining useful life of power transformers is decreased, and all kinds of partial discharge might happen for the degradation of the insulation structure in power transformers. Therefore, in order to make a balance between an integral remaining life of transformers and economical benefits, it's necessary to predict, calculate and monitor the inner temperature of power transformers, which could guarantee the operation mode safely and economically in some certain circumstance. In this paper, the influence of the inner temperature of transformers to the aging of insulation structure is first introduced. Then the relationship between the inner temperature of transformers and load in summer and winter is analyzed by thermal circuit model, from which we obtained the top-oil temperature of a certain transformer in different ambient temperature. And the data we measured shows that there is certain accuracy of the data we calculated by using thermal circuit model, and the maximum error between the data we calculated and measured is lower than 5 degrees C. So there is a convenient way to estimate the inner temperature of transformers and guide the model of lifting loads. Besides, in the premise of remaining life and normal operation of transformers, the estimation of the inner temperature of transformers could be used to prompt economic performance.

A Simple Power Loss Evaluation Method for High-Frequency Transformers Based on Surface Temperature Measurement Within Wide Operation Range

A Loss Measurement Approach of Power Magnetic Components under Practical Power Electronics Conditions

Calculation Method of Winding Eddy-Current Losses for High-Voltage Direct Current Converter Transformers

Evaluation of the Calculation Method for Stray Losses in Structural Parts of HVDC Converter Transformers

In-Situ Measurement and Investigation of Winding Loss in High-Frequency Cored Transformers Under Large-Signal Condition

A practical technique to measure transformer losses in high frequency SMPS

High-Precision Simulation For Structure And Efficiency Optimization Of High-Power High-Frequency Transformer

ANALYSIS OF ELECTROMAGNETIC FIELDS AND EDDY CURRENT LOSSES IN LARGE POWER TRANSFORMERS

Determining the Broadband Loss Characteristics of Power Transformer Based on Measured Transformer Network Functions and Vector Fitting Method

Detailed Losses Analysis of High-Frequency Planar Power Transformer

On-Site Detecting Method For The Loss Characteristic In 110kv Power Transformer

Thermofluidic investigations of oil natural transformer: Closed‐loop modelling and experimental validation

Simulation of 500 kHz High Frequency Transformer Temperature Rise under Different Wave Excitation

Study on the Harmonic Losses of UHV Converter Transformer Windings Subject to Non-sinusoidal Load Current

Magneto-thermal coupling simulation and experimental verification for a three-winding high-frequency transformer

Analysis of Dynamic High Frequency Power Transformer Model under Power-Loss Constraint

The Dynamic Load Adjustment Of Power Transformers Based On The Inner Temperature

The On-Line Detecting Method for Transformer Loss

An improved model of hot-spot temperature for oil-immersed transformers based on multi-parameter fusion

Electromagnetic Field Analysis and Optimization Method of High-Temperature Superconducting Transformer under the Influence of Abnormal Voltage

Global Temperature Sensing for an Operating Power Transformer Based on Raman Scattering