Abstract:In order to predict VFTO (very fast transient overvoltage) distributions in the windings during transformer design stage, it is important to acquire the frequency range of the surge wave that could enter the transformer winding, and then model the windings in that frequency range. In GIS (gas insulated station), transformer is connected to bus through bushing and lead wire. The bushing capacitance to ground will bypass the high frequency components, so there should be a upper limit of the frequency components of the surge wave at the entrance of the transformer. In this paper, the transformer windings are modeled using MTL (multitransmission-line) model firstly, then the lumped equivalent circuit is formulated with the -type circuits, and finally the driving-point impedance and voltage transfer functions of the equivalent circuit are calculated using nodal analysis. The driving-point impedance of a model winding is calculated and compared with the measured result, and the validation of the equivalent circuit of transformer winding in the frequency range below 20 MHz is verified. Then the driving-point impedances of two real transformer windings are calculated with the equivalent circuit. Taking the lead impedance into consideration, the impedance of the winding is compared with the one of the bushing capacitance. The results show that most of the energy of the frequency components above 10 MHz in the surge wave will pass through the bushing capacitance and will not cause damage to transformer insulations.

Improved lumped parameter model for transformer fast transient simulations

Calculation of Very Fast Transient Overvoltage Distributions in Large Power Transformer Windings

Piecewise Frequency-domain Modeling of Large Power Transformer Windings for Very Fast Transient Overvoltage Simulations

Simulation and Analysis of Electromagnetic Properties at the Secondary Port of Electronic Current Transformers Under Very Fast Transient Overvoltage

The Numerical Simulation Method of Transformer Internal Short-Circuit Fault

Wide Band Modeling of Large Power Transformer Windings for Very Fast Transient Overvoltage (VFTO) Analysis

Modeling electromagnetic wave coupling and mode conversion effects in multitwisted bundle of twisted-wire pairs (MTB-TWP) above ground plane

Research on Transient Electric Field Distribution of High-Frequency Transformers Based on COMSOL and SIMULINK Co-simulation

A Modified Lumped Parameter Model of Distribution Transformer Winding

Dynamic Electromagnetic Force Analysis of a Power Transformer with Regulated Windings

Calculation of Fast Transient Voltage Distributions in Transformer Windings Using Generalized Eigenvalue Method

FE-based equivalent circuits for simulating transformer internal faults

Determination of equivalent parameters of the transformer winding for transient analysis

Calculation of Parameters in Transformer Winding Based on the Model of Multi-Conductor Transmission Line

Broadband Equivalent Circuit Modeling for Medium Voltage High-Frequency Transformers with Multi-Shielding Structure

High Order Distribute Circuit Model of Laminated Busbars and Its Order Reduction Techniques for Simulating Fast Turn-on and Turn-off Transients

A Circuit Model in a Wide Frequency Range for Power Transformer and Analysis of Its Characteristics

A reluctance-based electromagnetic transient model for the Sen Transformer with inter-turn fault

Inter-Turn Breakdown Fault Analysis and Winding Structure Optimisation of Winding of Dry-Type Transformers in Wind Farms

Simulations on Transient Characteristics of 500 Kv Capacitor Voltage Transformer

Steady-state Analysis of Internal Short Circuits of Multi-winding Power Transformer Part Ⅰ Modeling and Simulations