Abstract:Scaling the areal density, while maintaining a proper balance between media signal-to-noise, thermal stability and writability will soon require an alternative recording technology. Heat Assisted Magnetic Recording (HAMR) can achieve this balance by allowing high anisotropy media to be written by heating the media during the writing process (e.g. by laser light) to temporarily lower the anisotropy. Three major challenges of designing a HAMR head that tightly focuses light and collocates it with the magnetic field are discussed: 1) Magnetic Field Delivery, 2)Optical Delivery, and 3) Integration of Magnetic & Optical Field Delivery Components. Thousands of these HAMR heads were built into sliders and HGAs, and optical and scanning electron micrograph images are shown. Scanning near-field optical microscopy (SNOM) characterization of the HAMR head shows that the predicted ~λ/4 full-width half-maximum (FWHM) spot size can be achieved using 488 nm light (124 nm was achieved). SNOM images also show that wafer level fabricated apertures were able to effectively eliminate sidelobes from the focused spot intensity profile. An MFM image of HAMR media shows that Non-HAMR (laser power off) was not able to write transitions in the HAMR specific media even at very high write currents, but transitions could be written using HAMR (laser power on), even at lower write currents. A cross-track profile is shown for a fully integrated HAMR head where the magnetic pole physical width is ~350 nm, but the written track is ~200nm, which demonstrates HAMR. A HAMR optimization contour shows that there is an optimum write current and laser power and that simply going to the highest write current and laser power does not lead to the best recording. Lastly, some prospects for advancing HAMR are given and a few key problems to be solved are mentioned.

The Role of Mfm Signal in Mark Size Measurement in Probe-Based Magnetic Recording on Coni/Pt Multilayers

Magnetic Film Thickness Effects on the Recording Performance of Perpendicular Media

Micromagnetic Modeling for Heat-Assisted Magnetic Recording

Heat-Assisted Magnetic Recording’s Extensibility to High Linear and Areal Density

Comparison of Micromagnetic and Point Probe Model in Magnetic Force Microscope Simulation

Dynamic Simulation of High-Density Perpendicular Recording Head and Media Combination

Studies of HAMR Recording by Hybrid Monte Carlo Micromagnetics

Measurement Mark Profiles of Digital Versatile Disc and Multilevel Read-Only Disc with Atomic Force Microscopy

RESEARCH ON PERPENDICULARLY MAGNETIZED ELECTROLESSLY PLATED COBALT ALLOY FILMS USING MFM

Heat Assisted Magnetic Recording with Matching Media and Recording Head Field

Micromagnetic Studies on Resolution Limits of Magnetic Force Microscopy Tips with Different Magnetic Anisotropy

Non-Contact Magnetic Force Microscopy of Recording Media by Ex Situ Tip Magnetization Reversal Method

Micromagnetic Studies of Ultrahigh Resolution Magnetic Force Microscope Tip Coated by Soft Magnetic Materials

Nanocavity Induced Light Concentration for Energy Efficient Heat Assisted Magnetic Recording Media

Magnetic Force Microscopy: High Quality Factor Two-Pass Mode

Compact Magnetic Force Microscope (MFM) System in a 12 T Cryogen-Free Superconducting Magnet

Heat Assisted Magnetic Recording with A Fully Integrated Recording Head

Analysis on the magnetic capping effect in heat assisted magnetic recording

Nanoscale Thermal Analysis for Heat-Assisted Magnetic Recording

Integrated Near Field Transducer Heat Assisted Magnetic Recording Head: Design And Recording Demonstration

Imaging, Manipulation, and Spectroscopic Measurements of Nanomagnets by Magnetic Force Microscopy