Abstract:Scaling the areal density, while maintaining a proper balance between media signal-to-noise, thermal stability and writability will soon require an alternative recording technology. Heat Assisted Magnetic Recording (HAMR) can achieve this balance by allowing high anisotropy media to be written by heating the media during the writing process (e.g. by laser light) to temporarily lower the anisotropy. Three major challenges of designing a HAMR head that tightly focuses light and collocates it with the magnetic field are discussed: 1) Magnetic Field Delivery, 2)Optical Delivery, and 3) Integration of Magnetic & Optical Field Delivery Components. Thousands of these HAMR heads were built into sliders and HGAs, and optical and scanning electron micrograph images are shown. Scanning near-field optical microscopy (SNOM) characterization of the HAMR head shows that the predicted ~λ/4 full-width half-maximum (FWHM) spot size can be achieved using 488 nm light (124 nm was achieved). SNOM images also show that wafer level fabricated apertures were able to effectively eliminate sidelobes from the focused spot intensity profile. An MFM image of HAMR media shows that Non-HAMR (laser power off) was not able to write transitions in the HAMR specific media even at very high write currents, but transitions could be written using HAMR (laser power on), even at lower write currents. A cross-track profile is shown for a fully integrated HAMR head where the magnetic pole physical width is ~350 nm, but the written track is ~200nm, which demonstrates HAMR. A HAMR optimization contour shows that there is an optimum write current and laser power and that simply going to the highest write current and laser power does not lead to the best recording. Lastly, some prospects for advancing HAMR are given and a few key problems to be solved are mentioned.

Dynamic Simulation of High-Density Perpendicular Recording Head and Media Combination

Calculation Of Dynamic Write Field For Perpendicular Recording Head

A Fast Fourier Transform on Multipole Algorithm for Micromagnetic Modeling of Perpendicular Recording Media

Micromagnetic Analysis of Transition Noise for High-Density Perpendicular Recording

Magnetic Film Thickness Effects on the Recording Performance of Perpendicular Media

Micromagnetic Simulation of FeCo Write Head in Perpendicular Recording Hard Disk Drives

Studies of Deep-Submicrometer Ultranarrow-Track Recording by Composite Simulation Models

Micromagnetic Modeling for Heat-Assisted Magnetic Recording

Micromagnetic Modeling Simulations And Applications

Heat Assisted Magnetic Recording with Matching Media and Recording Head Field

Micromagnetic Studies Of Recording Process In Patterned Magnetic Media

Writing Field Analysis for Shingled Bit-Patterned Magnetic Recording

Design Consideration and Practical Solution of High-Performance Perpendicular Magnetic Recording Media

Integrated Near Field Transducer Heat Assisted Magnetic Recording Head: Design And Recording Demonstration

Micromagnetic Studies of Perpendicular Recording Fept Media with Controllable Grain Size Distributions

Heat-Assisted Magnetic Recording’s Extensibility to High Linear and Areal Density

Areal density optimizations for heat-assisted-magnetic recording of high density bit-patterned media

Exchange coupled composite media for heat assisted magnetic recording

Impact of Media Design on Track Edge in Perpendicular Magnetic Recording

Perspective of read heads for ultra-high recording densities and associated noise issues

Heat Assisted Magnetic Recording with A Fully Integrated Recording Head