Abstract:Critical Dimension measurement in the final slider-level fabrication is essential in the development and manufacture of magnetic read/write heads for hard disk drives (HDD). It validates the device level geometry that plays a dominant role in the magnetic performance of the writer and provides critical feedback to the wafer-level head fabrication process control. Measurement at the slider-level affords the true Air Bearing Surface (ABS) view of the real device that can only be approached by the destructional cross-section at wafer level [1,2]. While the large set of CDSEM images of writer ABS at slider level enables an excellent statistical view of wafer uniformity, it also poses special challenges to the metrology due to a substantial number of variations from the upstream wafer process. The large structure variations observed at the sliderlevel is particularly prevalent in the initial development phase where large DOE (Design of Experiment) are designed to produce intended structure variations, and low process maturity yields large unintended variations among the devices. A traditional metrology used in such a variant data set requires extensive tuning or even a set of separate solutions with each solution in the set only applicable to a small subset of the variations. However, this approach is inefficient and demands high engineer resources. In this work, we use a machine learning based metrology approach to process the large set of magnetic writer device images at the slider level. For the current study, we use a model-based solution that was trained with deep learning (DL) using a dataset from 4 different head designs. The model aims to retrieve precise boundaries of the head to perform accurate measurements. We demonstrate the progressive robustness of the model-based solution by expanding the training set to measure the CD of writer poles with different designs and large process variations due to the intrinsic wafer level structure variation and the image distortions from the slider fabrication process. In addition, we will demonstrate the efficiency of the Deep Learning (DL) based solution in comparison with traditional metrology and manual measurements on the same set of data.

Measurement Mark Profiles of Digital Versatile Disc and Multilevel Read-Only Disc with Atomic Force Microscopy

Microstructure Measurement Method of Novel Multi-Level Run-Limited-Length Read Only Discs Using the Atomic Force Microscope

Theoretical and Experimental Analyses of Recording Mark Microstructures in Signal Waveform Modulation Optical Disc

Surface Profile Measurement of Micro-Optics by Using a Long Stroke Atomic Force Microscope

Applications Of Afm Technology In Cd-R R&D

Applications of AFM Technology in CD-R Research and Development

Molecular Dynamics Simulation of Form Measurement Process of Soft Materials Using Atomic Force Microscope

Simulation analysis and experimental validation of a new multi-level read-only optical recording method

The Role of Mfm Signal in Mark Size Measurement in Probe-Based Magnetic Recording on Coni/Pt Multilayers

Measurement of Sub-Surface Microstructures Based on a Developed Ultrasonic Atomic Force Microscopy

Multi-Level Recordable Disc Using Signal Waveform Modulation Recording Method

Modeling and process of mastering for multi-level run-length-limited optical discs

Modeling and Realization of a Multilevel Read-Only Disk

Research of the Atomic Force Microscopy Profilometer System

Analysis of Differential Phase Detection Signal of a Novel Multi-Level Read-Only Disc

Profile Measurements of Micro-Aspheric Surfaces Using an Air-Bearing Stylus with A Microprobe

Study of the Multi-Level Reflection Modulation Recording for Phase Change Optical Disks

Optical and Magneto‐optical Characterization for Multi‐dimensional Multi‐level Optical Recording Material

A dual-probe three-dimensional profile measurement system

Multilevel Optical Data Recording Methods on Phase-Change Media

Application of machine learning-based metrology for writer main pole CD measurement by CDSEM