Abstract:A new dual-imaging-unit atomic force microscope (DIU-AFM) was developed for wide-range length metrology. In the DIU-AFM, two AFM units were combined, one as a reference unit, and the other a test one. Their probes with Z piezo elements and tips were horizontally set in parallel at the same height to reduce errors due to geometric asymmetry. An XY scanner was attached to an XY block that was able to move in the X direction with a step of about 500 nm. A standard porous alumina film was employed as the reference sample. Both reference sample and test sample were installed at the center of the AT scanner on the same surface and were simultaneously imaged. The two images had the same lateral size, and thus the length of the test sample image could be accurately measured by counting the number of periodic features of the reference one. The XY block together with the XY scanner were next moved in the X direction for about 1.5 mum and a second pair of reference and test images were obtained by activating the scanner. In this way, a series of pairs of images were acquired and could be spliced into two wide-range reference and test images, respectively. Again, the two spliced images were of the same size and the length of test image was measured based on the reference one. This article presents a discussion about the structure and control of the DIU-AFM system. Some experiments were carried out on the system to demonstrate the method of length calculation and measurement. Experiments show a satisfactory result of wide-range length metrology based on the hexagonal features of the porous alumina with a periodic length of several tens of nanometers. Using this method the DIU-AFM is capable of realizing nanometer-order accuracy length metrology when covering a wide range from micron to several hundreds of microns, or even up to millimeter order. (C) 2004 Wiley-Liss, Inc.

Surface Profile Measurement of Micro-Optics by Using a Long Stroke Atomic Force Microscope

Towards High Accuracy Surface Profile Characterization in Atomic Force Microscopy

Profile Measurements of Micro-Aspheric Surfaces Using an Air-Bearing Stylus with A Microprobe

High Quality-Factor Quartz Tuning Fork Glass Probe Used In Tapping Mode Atomic Force Microscopy For Surface Profile Measurement

Development of a Large-Range Atomic Force Microscope Measuring System for Optical Free Form Surface Characterization

Research of the Atomic Force Microscopy Profilometer System

Rapid Measurement Of A High Step Microstructure With 90 Degrees Steep Sidewall

Atomic Force Microscopy Deep Trench And Sidewall Imaging With An Optical Fiber Probe

A Novel Atomic Force Microscope with High Stability and Scan Speed

Measurement of Sub-Surface Microstructures Based on a Developed Ultrasonic Atomic Force Microscopy

Rapid Characterization of Nano-Scale Structures in Large-Scale Ultra-Precision Surfaces

Novel Metrological Tuning Fork Atomic Force Microscope for Optical Surface Characterization

Long-working-distance Linnik Microscopic Interferometry for Measuring the Surface Profile of Microstructures

Atomic Force Microscope in Liquid with A Specially Designed Probe for Practical Application

A compact CCD-monitored atomic force microscope with optical vision and improved performances.

A Novel Atomic Force Microscope Operating in Liquid with Open Probe Unit and Optimized Laser Tracking System

A Large-Sample Atomic Force Microscope Observing in Both Air and Liquid

A novel scanning tunneling microscopy for long range and high aspect ratio measurement

Long range metrological atomic force microscope with versatile measuring head

Profilometer for Measuring Superfine Surfaces

Wide-range length metrology by dual-imaging-unit atomic force microscope based on porous alumina.