Abstract:Further investigation on the definition of the representative strain in conical indentation was performed in this work. In particular, the representative strains proposed in the work of Cao et al. [J. Mater. Res. 20, 1194 (2005)] and Ogasawara et al. [J. Mater. Res. 20, 2225 (2005)] were discussed in detail. For the method using the energy-based representative strain [Cao et al., J. Mater. Res. 20, 1194 (2005)], it is shown that it can be extended to a wider range of material properties (from nearly fully plastic materials to highly elastic materials). For the stress-state-based definition of the representative strain, we found, in contrast with the results reported in the work of Ogasawara et al. [J. Mater. Res. 20, 2225 (2005)], that similar to the constant representative strain reported by Dao et al. [Acta Mater. 49, 3899 (2001)], it works well only for a limited range of engineering materials. Based on this premise, novel definitions of the representative strain, which can lead to a one-to-one relationship with high level of accuracy between the reduced Young's modulus, the indentation loading curvature, and the representative stress are further presented. Detailed numerical analysis performed on nine kinds of engineering materials verified the effectiveness of the proposed representative strains and corresponding dimensionless functions. Experimental verification using the data for the ultrafine crystalline Ni further showed that the results reported in this paper have the potential to be applied in practice.

Residual Strains of Aluminum Alloy Characterized by Nanoindentation

A Method of Calculating Residual Stresses Through Elastic Modulus Measured by Nanoindentation

Investigation of fatigue mesoscopic mechanical properties of a nickel-based superalloy by instrumented microindentation measurements

Study on Measurement Method of Interior Stress Distributions in Engineering Rolled-Plates

Estimation of Mechanical Properties of Aluminum Alloy Based on Indentation Curve and Projection Area of Contact Zone

Investigation on Dynamic Hardness and High Strain Rate Indentation Size Effects in Aluminium (110) Using Nano-Impact

Plastic Characterization of Metals by Combining Nanoindentation Test and Finite Element Simulation

Measuring the effect of residual stress on the machined subsurface of Inconel 718 by nanoindentation

Numerical simulation for measuring yield strength of thin metal film by nanoindentation method

A New Method for Reliable Determination of Strain-Rate Sensitivity of Low-Dimensional Metallic Materials by Using Nanoindentation

Effects of Yield Strength and Plastic Strain Exponent on Nanoindentation Process

Residual Elastic Stress–strain Field and Geometrically Necessary Dislocation Density Distribution Around Nano-Indentation in TA15 Titanium Alloy

Plastic Strain Effect in Progressive Multi-Cycle Nano-Indentation Measurement

Origin of strain softening in a nanograined Al alloy

Determining plastic properties of a material with residual stress by using conical indentation

Effect of Strain Rate on Deformation Behavior of AlCoCrFeNi High-Entropy Alloy by Nanoindentation

Analysis of the nanoindentation load–displacement curves measured on high-purity fine-grained alumina

Spherical indentation method for estimating equibiaxial residual stress and elastic–plastic properties of metals simultaneously

Further Investigation on the Definition of the Representative Strain in Conical Indentation

Novel method for measuring surface residual stress using flat-ended cylindrical indentation

Establishment of Simplified Constitutive Relationship for 3J21 Alloy and Its Nano-indentation Test