Abstract:The flow condensation heat transfer coefficient of R134a inside two helical micro-fin tubes with outer diameter of 6.35 mm and helical angles of 18o and 28o respectively were experimentally studied at a high mass flux ranging from 500 to 1100 kg m−2 s−1. The condensation temperatures are 35°C, 40°C and 45°C, and the vapor qualities ranges from 0.95 to 1.00 at the inlet section and from 0.00 to 0.05 at the outlet section. Experimental results show that there are annular and intermittent flow regimes inside the tube under experimental conditions, the ratio of annular flow region to the total heat transfer region is about 70%. The liquid film flow changes from rotational flow to coexistence of rotational and horizontal flows when the vapor quality is 0.475±0.08, 0.486±0.06 and 0.521±0.05, respectively and the corresponding saturation temperature is 35°C, 40°C and 45°C. Based on the experimental data, the heat transfer coefficient increases with increasing mass flux and fin helical angle, and with decreasing saturation temperature and Reynolds number of cooling water. In addition, the heat transfer coefficient of annular flow is greater than that of intermittent flow, in other words, the heat transfer coefficient increases with increasing vapor quality. The heat transfer coefficient obtained at high mass flux was compared with the calculated data of some published correlations used at low mass flux. It was found that most correlations underestimate the experimental heat transfer coefficient inside the micro-fin tube, and these prediction deviation increases with increasing mass flux and fin helical angle. By introducing some dimensionless numbers as well as considering the flow mechanism of liquid film inside the tube, two heat transfer coefficient correlations were proposed based on the experimental data. The ratio of liquid film thickness to fin height was used to characterize whether the liquid film flow is rotational flow or coexistence of rotational and horizontal flows in the proposed correlation, which shows a better prediction accuracy with a mean deviation of less than 7.3%.

Influence of fin height on evaporators using 5 mm internal finned tube and the optimization of fin height

Comparative research on the heat transfer efficiency of evaporators with different structures used in a large quick-freeze plant

Experimental Study on High-efficient Evaporator in Large Quick-freeze Equipment

Experimental Study of Condensation Heat Transfer of R134a Inside the Micro-Fin Tubes at High Mass Flux

Theoretical and Experimental Analyses of Two-Phase Flow Condensation Heat Transfer Inside the Horizontal Micro-Fin Tube

Fin Design for an Evaporator with Small Diameter Microgroove Tubes

Simulation and Optimization Study on the Performance of Fin-and-Tube Heat Exchanger

Configuration Design and Experimental Investigation of Fin Used in 5mm Fin-and-tube Heat Exchangers for Air Conditioner

Condensation Pressure Drop and Heat Transfer in 5-Mm-od Micro-Fin Tubes

A numerical model for convective-condensation heat transfer of flue gas and its application on fin efficiency calculation

Experimental and numerical investigation on air-side performance of fin-and-tube heat exchangers with various fin patterns

Fin design for fin-and-tube heat exchanger with microgroove small diameter tubes for air conditioner

Correlation of Evaporation Heat Transfer Inside 8.8 Mm and 7.14 Mm Horizontal Round Micro-Fin Tubes

EVAPORATION AND CONDENSATION HEAT TRANSFER IN HORIZONTAL MICRO-FIN TUBES

Experimental Investigation of Evaporation Heat Transfer Inside Horizontal Micro-Fin Tubes

Simulation of Effect of Air Velocity Distribution on Performance of Two-Row Finned Tube Evaporator with One Flow Path

Influence Of 0 Degrees Helix Angle Micro Fins On Flow And Heat Transfer Of R32 Evaporating In A Horizontal Mini Multichannel Flat Tube

Influence of condensate inundation on heat transfer of R134a condensing on three dimensional enhanced tubes and integral-fin tubes with high fin density

Experimental research on refrigerant condensation heat transfer and pressure drop characteristics in the horizontal microfin tubes

Evaporation Performance Research of New Micro-fin Copper Tube

Simulation Study on Fin-tube Condenser