Abstract:The flow condensation heat transfer coefficient of R134a inside two helical micro-fin tubes with outer diameter of 6.35 mm and helical angles of 18o and 28o respectively were experimentally studied at a high mass flux ranging from 500 to 1100 kg m−2 s−1. The condensation temperatures are 35°C, 40°C and 45°C, and the vapor qualities ranges from 0.95 to 1.00 at the inlet section and from 0.00 to 0.05 at the outlet section. Experimental results show that there are annular and intermittent flow regimes inside the tube under experimental conditions, the ratio of annular flow region to the total heat transfer region is about 70%. The liquid film flow changes from rotational flow to coexistence of rotational and horizontal flows when the vapor quality is 0.475±0.08, 0.486±0.06 and 0.521±0.05, respectively and the corresponding saturation temperature is 35°C, 40°C and 45°C. Based on the experimental data, the heat transfer coefficient increases with increasing mass flux and fin helical angle, and with decreasing saturation temperature and Reynolds number of cooling water. In addition, the heat transfer coefficient of annular flow is greater than that of intermittent flow, in other words, the heat transfer coefficient increases with increasing vapor quality. The heat transfer coefficient obtained at high mass flux was compared with the calculated data of some published correlations used at low mass flux. It was found that most correlations underestimate the experimental heat transfer coefficient inside the micro-fin tube, and these prediction deviation increases with increasing mass flux and fin helical angle. By introducing some dimensionless numbers as well as considering the flow mechanism of liquid film inside the tube, two heat transfer coefficient correlations were proposed based on the experimental data. The ratio of liquid film thickness to fin height was used to characterize whether the liquid film flow is rotational flow or coexistence of rotational and horizontal flows in the proposed correlation, which shows a better prediction accuracy with a mean deviation of less than 7.3%.

Influence Of 0 Degrees Helix Angle Micro Fins On Flow And Heat Transfer Of R32 Evaporating In A Horizontal Mini Multichannel Flat Tube

Experimental Study of Condensation Heat Transfer of R134a Inside the Micro-Fin Tubes at High Mass Flux

Theoretical and Experimental Analyses of Two-Phase Flow Condensation Heat Transfer Inside the Horizontal Micro-Fin Tube

Two-Phase Flow Heat Transfer In Micro-Fin Tubes

Experimental Investigation of Evaporation Heat Transfer Inside Horizontal Micro-Fin Tubes

Numerical Investigation on Flow Boiling Heat Transfer in Elliptic Microchannel Heat Exchanger with Micro Fins

EVAPORATION AND CONDENSATION HEAT TRANSFER IN HORIZONTAL MICRO-FIN TUBES

New experimental data of CO 2 flow boiling in mini tube with micro fins of zero helix angle

Pressure drop of R134a in mini channels with micro pin fins during flow boiling

R410A and R32 condensation heat transfer and flow patterns inside horizontal micro-fin and 3-D enhanced tubes

Flow Condensation Heat Transfer and Pressure Drop in Horizontal Micro-Fin Tubes

R32 flow boiling in horizontal mini channels: Part II Flow-pattern based prediction methods for heat transfer and pressure drop

Correlation of Evaporation Heat Transfer Inside 8.8 Mm and 7.14 Mm Horizontal Round Micro-Fin Tubes

Experimental Study of Boiling Heat Transfer in Smooth/micro-Fin Tubes of Four Refrigerants

Numerical Investigation on R32 Flow Boiling in Smooth Mini-Tube

Condensation Heat Transfer and Pressure Drop of R22 in 5-Mm Diameter Microfin Tubes

Flow Boiling Heat Transfer Characteristics on Micro-Pin-finned Surfaces in a Horizontal Narrow Microchannel

Flow Boiling in Horizontal Annuli Outside Horizontal Smooth, Herringbone and Three-Dimensional Enhanced Tubes

Boiling Heat Transfer for R134a in the Horizontal Tubes with Three Dimensional Inner Micro Fins

Numerical simulation on flow boiling heat transfer of R32 in micro/mini-channels

Experimental Investigations of Flow Boiling Heat Transfer Performance in Finned Micro-Channels