Abstract:Thermoelectric energy conversion is an all solid-state technique offering high reliability and power density, desirable properties in mobile waste heat recovery applications. It is generally less efficient than vapor-based thermodynamic cycles. The efficiency of thermoelectric (TE) power generators and heat pumps is characterized by the thermoelectric figure of merit zT = S2σT/κ; here S is the thermopower or Seebeck coefficient of the TE material, κ and σ = 1/ρ are its thermal and electrical conductivities (ρ is the resitivity). Recent research led to a doubling of zT over the last decade. Featuring lattice thermal conductivities intrinsically limited by very strong phonon-phonon interactions to the amorphous limit,[1] small band gaps[2–4] and interesting transport properties,[2,5] some ternary I–V–VI2 intermetallic compounds like AgSbTe2 can reach a thermoelectric figure of merit zT ∼ 1.3 at 400 K[6] when doped p-type. Its alloys with GeTe, called “TAGS”,[7–9] and with PbTe, called “LAST”,[10] are the materials that have some of the highest known zT near 500–800 K, the temperature of automotive exhaust where heat recovery applications are being envisioned. Here we complement the work on AgSbTe2-PbTe and AgSbTe2-GeTe and report the first systematic study of the thermoelectric properties of AgSbTe2SnTe alloys covering the entire alloy range. This goes beyond early work[7,11] concentrated on the SnTe-rich side, and mixed alloys of SnTe, PbTe and AgSbTe2, “LASTT”.[12,13] In large-scale energy recovery applications, SnTe-based alloys would avoid lead-abatement legislation, the technological problems associated with a crystallographic phase transition in GeTe-based alloys, and the very high cost of Ge. The high zT of p-type AgSbTe2 stems from the large density of states (DOS) of the valence band[2] and the intrinsically ultralow thermal conductivity,[1] but it is difficult to dope AgSbTe2 sufficiently to get a good zT. Binary SnTe is plagued by the existence of an irreducible concentration of Sn vacancies which makes it impossible to reach a low hole concentration. Here we

Effect of Ag/Sb Ratio on the Thermoelectric Properties of (gete) 85 (Agysb2-Yte3-y)15 TAGS Alloys

Thermoelectric properties of (GeTe)1-x[(Ag2Te)0.4(Sb2Te3)0.6]x alloys

Thermoelectric Properties of Non-Stoichiometric Agsbte2 Based Alloys with A Small Amount of Gete Addition

Improved Thermoelectric Properties of (gete) 90 (ag Y Sb 2− Y Te 3− Y ) 10 by Tuning the Ag-to-Sb Ratio

Phase compositions, nanoscale microstructures and thermoelectric properties in Ag2-ySbyTe1+y alloys with precipitated Sb2Te3 plates

High-Performance (Ag x SbTe x /2+1.5 ) 15 (GeTe) 85 Thermoelectric Materials Prepared by Melt Spinning

Ioffe-Regel Limit And Lattice Thermal Conductivity Reduction Of High Performance (Agsbte2)(15)(Gete)(85) Thermoelectric Materials

Nanostructures in High-Performance (Gete)(x)(agsbte(2))(100-X) Thermoelectric Materials

Doping Effect on Thermoelectric Properties of Nonstoichiometric AgSbTe 2 Compounds

Influence of Ag2te Doping on the Thermoelectric Properties of P-Type Bi0.5sb1.5te3 Bulk Alloys

Mid-temperature Thermoelectric Performance of Zone-Melted Sb2(Te,Se)3 Alloys Near Phase Transition Boundary

Transport properties and valence band feature of high-performance (GeTe)85(AgSbTe2)15 thermoelectric materials

Transport properties and valence band feature of high-performance (GeTe)<sub>85</sub>(AgSbTe<sub>2</sub>)<sub>15</sub>thermoelectric materials

Influence of Ag_2Te Doping on the Thermoelectric Properties of p-type Bi_(0.5)Sb_(1.5)Te_3 Bulk Alloys

Natural Microstructure and Thermoelectric Performance of (gete) 80 (ag Y Sb 2− Y Te 3− Y ) 20

Structural transformation and thermoelectric performance in Ag2Te1−Se solid solution

High entropy effect on thermoelectric properties of nonequilibrium cubic phase of AgBiSe2-2xSxTex with x = 0-0.6

SnTe–AgSbTe2 Thermoelectric Alloys

High entropy effect on thermoelectric properties of the nonequilibrium cubic phase of AgBiSe2-2 xSxTex with x = 0-0.6

Phase-modulated mechanical and thermoelectric properties of Ag2S1-xTex ductile semiconductors

Thermoelectric Properties of Quaternary Ag-Bi-Sb-Te Alloys