Abstract:High strength and high conductivity Cu-based materials are key requirements in high-speed railway and high-field magnet systems. Cu-Fe alloys represent one of the most promising candidates due to the cheapness of Fe compared to Cu-Ag and Cu-Nb alloys. The high strength of Cu-Fe alloys primarily relies on the high density of the Cu/Fe phase interface, which is controlled by the co-deformation of the Cu matrix and Fe phase. In this study, our main attention was focused on the deformation behavior of the Fe phase using different scales. Cu-2.5% Fe-0.2% Cr (in weight) and Cu-6% Fe alloys were cast, annealed, and cold drawn into wires to investigate their microstructure and properties evolution. Cu-6% Fe contains Cu matrix and Fe, which become the primary particles in the micrometer scale after solution treatment. Cu-2.5% Fe-0.2% Cr contains Cu matrix and Fe precipitate particles in a nanometer scale after solution and aging treatment. The Fe primary particles were elongated and evolved into ribbons in a nanometer scale while the Fe precipitate particles were hardly deformed even at a drawing strain of 6. The reason for the unchanging characteristics of Fe precipitate particles is due to the size effect and incoherent phase interface of Cu matrix and Fe precipitate particles. The strength of both Cu-6% Fe and Cu-2.5% Fe-0.2% Cr alloys increases with the increase in the drawing strain. The electrical resistivity of Cu-6% Fe gradually increases and that of Cu-2.5% Fe-0.2% Cr keeps almost constant with the increase in the drawing strain.

Effect of Rare Earth Addition on Microstructural, Mechanical and Electrical Characteristics of Cu-6%Fe Microcomposites

Effects of rare-earth additions on the microstructure and strength of Cu–Ag composites

Effects of Rare Earth Additions on Microstructure and Properties of Cu-6%Fe Filamentary Composites

Effects of rare earth elements on annealing characteristics of Cu–6wt.% Fe composites

Attaining Exceptional Electrical Conductivity in Cu-Fe Composite by Powder Rolling Strategy

Effects of Cr addition on the microstructural, mechanical and electrical characteristics of Cu–6wt.%Ag microcomposite

Effect of Fe Content on the Microstructure and Mechanical and Electrical Properties of Cu-Fe In Situ Composites

Effects of Rare Earth Additions on Compound Structure and As-Annealed Properties of Cu-12%Ag

Microstructure and Properties of Cold Drawing Cu-2.5% Fe-0.2% Cr and Cu-6% Fe Alloys

Microstructure evolution and properties of Cu–Ag microcomposites with different Ag content

Achieving Homogeneous Fe Distribution and High Strength in Cu-Fe Composite Consolidated by Powder Rolling

Microstructure and properties of Cu–Ag, Cu–Ag–Cr and Cu–Ag–Cr–RE alloys

Effects of Cr and Zr additions on the microstructure and properties of Cu-6wt.% Ag alloys

Microstructure and Properties of Cu–Fe Microcomposites with Prior Homogenizing Treatments

Microstructure and Hardness of Cu-12% Fe Composite at Different Drawing Strains

Relationships between mechanical strength and electrical conductivity for Cu–Ag filamentary microcomposites

Effect of Rare Earth Oxide Addition on the Microstructure and Properties of Ultrafine Grain W-20Cu Composites

Microstructure and Properties of Heavily Drawn Cu-Ag-Fe Composites

Effects of Zr and Mg alloying on microstructure and properties of Cu-Cr-Si alloys

Influences of Fe Content and Cold Drawing Strain on the Microstructure and Properties of Powder Metallurgy Cu-Fe Alloy Wire

Strain Compatibility Behavior in Cu-6%Ag Alloy During Drawing into Filamentary Structure