Abstract:Based on electron backscatter diffraction (EBSD), hollow structures of Ni foam struts fabricated by electroplating on a chemically removable template were observed. Three-dimensional (3D) pore structures of Ni foams were also obtained using X-ray computed tomography (CT), and microstructural features such as porosity, pore size and strut thickness were statistically quantified. Evolution of microstructure and mechanical properties during ex situ compression of open-cell Ni-foams was investigated based on X-ray CT, and experimental results were compared with predictions by the finite element method (FEM). 3D microstructures obtained by X-ray CT revealed that the stress drop started with the buckling of struts at the center of the Ni-foams. The flow stress increased after the buckling of the struts spreads to most of the regions. For effective simulation of the compressive deformation and determination of the microstructural evolution, small domains of interest were selected from the entire set of observed 3D microstructures based on X-ray CT, and struts of Ni foams with a hollow structure were simplified with relevant thin-solid struts. Numerical 3D modeling comprehensively disclosed that compression caused the transverse buckling of the struts, with the bending and buckling of struts thus reducing the stress. Thickness variation of the struts causes a change in the porosity of Ni-foams without a change in pore shape or connectivity. The overall range of strut thickness was from 59 to 133 μm, and the range of porosity values was from 80% to 93.7%. A stress drop was predicted with a decrease in the strut thickness or an increase in the porosity, as measured experimentally. It was also found that the stress drop contributed to an increase in the calculated energy absorption efficiency.

Research on Microstructure Evolution and Deformation for Closed-Cell Aluminium Foams in Compression by SXR-CT Technique

Mechanical Simulation of the Localized Deformation in the Aluminum Foams: A Three-Dimensional (3d) Structure Based Study

Study on Cell Deformation of Low Porosity Aluminum Foams under Quasi‐Static Compression by X‐Ray Tomography

Damage kinetics and compression behavior of Al alloy foam using in situ SRμCT

Early Compressive Deformation of Closed-Cell Aluminum Foam Based on a Three-Dimensional Realistic Structure

Investigations of the failure behaviors of open-cell copper foam based on in-situ X-ray tomography compression experiments and image reconstructed finite element modeling

High temperature and mesostructure effect on aluminum foam compression responses

Micro-CT in the mechanical properties and energy absorption of closed-cell aluminium foam

Factors affecting the microstructure of a fine ceramic foam

Compressive Performance and Deformation Mechanism of the Dynamic Gas Injection Aluminum Foams

Study on the Compression Properties and Deformation Failure Mechanism of Open‐Cell Copper Foam

Analysis of Microstructure Evolution and Mechanical Properties during Compression of Open-Cell Ni-Foams with Hollow Struts Using Micro-CT and FEM

Compression Behavior of Metal Foams with Real Pore Structures Through CT Scan Images

Microstructure and Compressive Properties of Aluminum Foams Made by 6063 Aluminum Alloy and Pure Aluminum

Effects of cell wall property on compressive performance of aluminum foams

Aluminum Foam Sandwich: Pore Evolution Mechanism Investigation and Engineering Preparing Optimization

3-D Microstructural Distribution and Mechanical Analysis of HPDC Hypereutectic Al-Si Alloys via X-Ray Tomography

Influences of Increased Pressure Foaming on the Cellular Structure and Compressive Properties of In Situ Al-4.5%Cu-xTiB2 Composite Foams with Different Particle Fraction

Modeling of Macro-Deformation Behavior of Thin-Walled Aluminum Foam by Gas Injection Method

Quasi-static Deformation Mechanism and Compressive Properties of Aluminum Foams Fabricated by Friction Stir Processing

Coupling Effect Of Porosity And Cell Size On The Deformation Behavior Of Al Alloy Foam Under Quasi-Static Compression