Abstract:Utilization of propane in solid oxide fuel cells (SOFCs) is desired for commercial applications. However, the susceptibility of conventional Ni-based anode to coking is still a technical challenge. Developing an efficient catalyst for hydrogen production through partial oxidation of propane is a feasible approach to address this issue. In fact, hydrogen production from propane partial oxidation is profoundly determined by catalyst performance, which further affects the fuel cell efficiency. In this study, a robust and efficient catalyst is developed by incorporating inexpensive TiO2 into Ni-Co/Al2O3 catalyst. The results suggested that an appropriate amount of TiO2 in catalyst support could regulate the interaction between active metal and Al2O3 support therefore inhibiting catalyst carbon deposition and sintering. Also, TiO2 addition is conducive to the catalyst regeneration process by reducing the activation energy of oxidative decarburization. Hydrogen yield was efficiently promoted by the synthesized catalyst. Consequently, under the equivalent hydrogen (160 ml/min) produced over the catalyst, the SOFCs, with a cathode area of 15 cm2, display impressive performance (maximum power density, 404 mW/cm2) and excellent stability. Through cost-benefit analysis, the application of the synthesized catalyst is considered for great advantages in capital and energy saving. Ultimately, this work might offer a novel point of view for developing a low-cost, robust and efficient catalyst towards indirect hydrogen production for SOFCs.

Operation of Anode-Supported Solid Oxide Fuel Cells on Propane–air Fuel Mixtures

Propane Fueled Solid Oxide Fuel Cells

Use of A Catalyst Layer for Propane Partial Oxidation in Solid Oxide Fuel Cells

80 Hours operation of a tubular solid oxide fuel cell using propane/air

Direct Operation of Solid Oxide Fuel Cells with Methane Fuel

Operation of ceria-electrolyte solid oxide fuel cells on iso-octane–air fuel mixtures

A High-Performance No-Chamber Fuel Cell Operated on Ethanol Flame

Solid Oxide Fuel Cells Operated by Internal Partial Oxidation Reforming of Iso-Octane

Direct liquid methanol-fueled solid oxide fuel cell

High-rate Electrochemical Partial Oxidation of Methane in Solid Oxide Fuel Cells

Direct Operation of Solid Oxide Fuel Cells on Low-Concentration Oxygen-Bearing Coal-Bed Methane with High Stability

Membrane-assisted Propane Partial Oxidation for Solid Oxide Fuel Cell Applications

Advance in Portable Solid Oxide Fuel Cells Operating on Propane

Sorption-enhanced propane partial oxidation hydrogen production for solid oxide fuel cell (SOFC) applications

The Performance of a Single-Chamber Solid Oxide Fuel Cell Operated under Thin Oxygen Condition Within Methane Fuel

A Robust Flat-Chip Solid Oxide Fuel Cell Coupled with Catalytic Partial Oxidation of Methane

Enhancing hydrogen production from propane partial oxidation via CO preferential oxidation and CO2 sorption towards solid oxide fuel cell (SOFC) applications

Performance Characteristics of a Micro-tubular Solid Oxide Fuel Cell Operated with a Fuel-rich Methane Flame

Direct Flame SOFCs with La[sub 0.75]sr[sub 0.25]cr[sub 0.5]mn[sub 0.5]o[sub 3−δ]∕ni Coimpregnated Yttria-Stabilized Zirconia Anodes Operated on Liquefied Petroleum Gas Flame

Enhancement effect of catalyst support on indirect hydrogen production from propane partial oxidation towards commercial solid oxide fuel cell (SOFC) applications

Thermodynamic and Experimental Assessment of Proton Conducting Solid Oxide Fuel Cells with Internal Methane Steam Reforming