Abstract:Under the special geological environment of the buried pipe, the ground is lost at the bottom of the pipe, which is created by various kinds of external factors. The pipe in the suspended state would be greatly deformed due to its own weight, internal pressure, and other factors, resulting in the failure of the pipeline. When a variable wall thickness weld occurs in the suspended section of the pipeline, the change of the pipeline stress will be more complicated and changeable. In this study, ABAQUS software is used to establish a pipe–soil model of variable wall thickness butt welds of suspended pipelines. The axial stress distribution with different affected factors in the pipe, the change of curvature, and Mises stress change of the entire pipe along the axial direction are obtained by analyzing the internal pressure, wall thickness ratio, suspended length, weld position, and cone length. The results show that the stress at the root of the weld changes significantly; therefore, the weld has a greater impact on the stress of the entire pipeline. The change of internal pressure has little effect on the stress at the pipe weld. As the suspended length increases, the change in stress at the weld is more obvious. When the weld seam is close to the soil, the support of the soil will gradually shift the maximum stress position of the pipe from the top of the pipe to the bottom of the pipe. With the increase in cone length, it will reduce the sudden change of pipe section and the change in stress effectively. The places where the curvature greatly changes along the axial direction are at the pipe–soil separation and the middle of the pipeline, while the stress reaches the maximum at the pipe–soil separation, and the place with the largest stress change is the weld in the middle of the pipeline.

Thermal Stress Analysis of A Large Diameter Curving Pipe in Service

Theoretical Analysis and Numerical Simulation of Large-Diameter and Thin-Wall Pipelines During Ultra-Deep J-Lay Installation

Theoretical Study on Upheaval Buckling of Subsea Pipelines with Temperature-Dependent Thermal Properties at Different Carbon Contents

Stress-Strain Analysis of Reducing Pipe Under Temperature

Stress Analysis of the Effect of Additional Load on the Butt Weld of Suspended Pipeline With Variable Wall Thickness

The Temperature and Thermal Stress Analysis of Steam Pipe and Correlative Branch Pipe with Finite Element Method

Surface Stress Analysis of Internally Corroded Pipes under External Pressure

Thermal, metallurgical and mechanical analysis of circumferentially multi-pass welded P92 steel pipes

Finite Element Analysis of the Thermal Stress of the Ceramic Composite Piping Prepared by Centrifugal-SHS

Resistance mechanism of partially embedded pipelines considering the influence of temperature fields

Stress analysis of heat exchange tube with inner and outer fins under convection heat transfer conditions

Numerical Analysis of Temperature Fields and Thermal Stress Fields in Heating Process of Large-Diameter Seamless Steel Pipe Blanks

Thermal fatigue analysis of district heating pipeline under variable frequency regulation of circulating water pump

Stress analysis of double-walled pipes undergone mechanical drawing process

The Thermal and Mechanical Behavior of a Joint Pipe System Calculated by Finite Element Method

Numerical simulation analysis of high-temperature bent sodium heat pipes

THERMAL POST-BUCKLING OF HIGH-TEMPERATUPE PIPELINE

A Generalized Thermal Deviation Factor to Evaluate the Comprehensive Stress of Tubes under Non-Uniform Heating

Stress Analysis of Ellipsoidal Head with Heating Spiral

Thermal hydraulic analysis of turbulent flow of superheated steam through multiple configurations of 3-D angular piping bend in power plant installations

Structural strength analysis of curved submarine pipes during pipeline connection