Abstract:The heat pipe cooled reactor is an advanced reactor design which is nearly solid-state with an array of in-core heat pipes for passive heat transfer. The local heat pipe failure probability is certainly high over the reactor lifetime. Therefore, the reactor design must include consideration of heat pipe failure accidents which needs to be explored in-depth. The Monte Carlo neutron transport code RMC was used with the general finite element analysis software ANSYS Mechanical to analyze the thermal/mechanical characteristics of a megawatt heat pipe cooled reactor for both normal and heat pipe failure conditions. The simulations were verified against a previous study with the predicted temperature distributions being consistent with each other with an absolute error of less than 3 K. Further analyses show that a 2-D model simulation can also well represent the 3-D model for heat pipe failure accident analyses. Sterbentz et al. (2017) simplified the heat pipe model with a constant temperature boundary condition along the evaporator wall of 950.15 K regardless of the heat load or heat pipe operating temperature. Therefore, a heat pipe subroutine was added to the codes to predict the heat pipe temperatures during a heat pipe failure accident. The results show that the heat pipe failure will cause larger temperature rises and stress concentrations. The heat pipe wall temperatures in the core differ from each other with the differences between the heat pipe loads during normal heat pipe operation and with failures reflecting the local effect of the heat pipe failures. The operating conditions far from the failure area are little affected (<20 K temperature change) by a single heat pipe failure. The effects of the heat pipe failure on the reactor core reactivity and local power distribution were also analyzed with a reactivity change of less than 5 pcm and a local power change of less than 0.1%. Therefore, the heat pipe failure can be analyzed in steady-state simulations with unchanged power distributions. (C) 2020 Elsevier Ltd. All rights reserved.

Thermal fatigue analysis of district heating pipeline under variable frequency regulation of circulating water pump

Fatigue Failure Analysis and Simulation Calculation of Submarine Suspended Pipelines

Thermal–mechanical Fatigue Behaviour of P92 T-piece and Y-piece Pipe

Thermal-Mechanical Fatigue Behavior of P92 T-Piece Pipe

Thermal Fatigue Analysis Model and Life Prediction of Pipe in Residual Heat Removal System

Theoretical and numerical research on thermal fatigue crack initiation direction in pipe of residual heat removal system

Thermal corrosion fatigue crack growth behavior and life prediction of 304SS pipeline structures in high temperature pressurized water

Thermo-mechanical Stress and Fatigue Damage Analysis on Multi-Stage High Pressure Reducing Valve

Analysis of Fluid Flow Characteristic with Different Temperature and Different Methods in T-junction Pipe

Simulation of Coupled Hydraulic–Thermal Characteristics for Energy-Saving Control of Steam Heating Pipeline

Pump-stopping-induced hydraulic oscillations in long-distance district heating system: Modelling and a comprehensive analysis of critical factors

Typical Damage Prediction and Reliability Analysis of Superheater Tubes in Power Station Boilers Based on Multisource Data Analysis

ANALYSIS OF TEMPERATURE FIELD AND THERMAL STRESS FOR EXTERNALLY CONNECTED PIPE SOCKETS OF REHEATER BY USING THE FINITE ELEMENT METHOD

Research on the fatigue properties of sub‐heat‐affected zones in X80 pipe

Numerical investigation on thermal behavior of high temperature heat pipe based on thermal resistance network model

Heat loss optimization and economic evaluation of a new fourth generation district heating triple pipe system

The Research on the Stress Analysis of Overhead Steam Pipeline

Fatigue Life Prediction of a Pump Turbine Runner

Simulation and Analysis on Control Effectiveness of TRVs in District Heating Systems

Heat pipe failure accident analysis in megawatt heat pipe cooled reactor

Sensitivity Analysis and Safety Adjustment of the Hydraulic Condition in District Heating Networks