Abstract:Under the special geological environment of the buried pipe, the ground is lost at the bottom of the pipe, which is created by various kinds of external factors. The pipe in the suspended state would be greatly deformed due to its own weight, internal pressure, and other factors, resulting in the failure of the pipeline. When a variable wall thickness weld occurs in the suspended section of the pipeline, the change of the pipeline stress will be more complicated and changeable. In this study, ABAQUS software is used to establish a pipe–soil model of variable wall thickness butt welds of suspended pipelines. The axial stress distribution with different affected factors in the pipe, the change of curvature, and Mises stress change of the entire pipe along the axial direction are obtained by analyzing the internal pressure, wall thickness ratio, suspended length, weld position, and cone length. The results show that the stress at the root of the weld changes significantly; therefore, the weld has a greater impact on the stress of the entire pipeline. The change of internal pressure has little effect on the stress at the pipe weld. As the suspended length increases, the change in stress at the weld is more obvious. When the weld seam is close to the soil, the support of the soil will gradually shift the maximum stress position of the pipe from the top of the pipe to the bottom of the pipe. With the increase in cone length, it will reduce the sudden change of pipe section and the change in stress effectively. The places where the curvature greatly changes along the axial direction are at the pipe–soil separation and the middle of the pipeline, while the stress reaches the maximum at the pipe–soil separation, and the place with the largest stress change is the weld in the middle of the pipeline.

The Research on the Stress Analysis of Overhead Steam Pipeline

Experimental and Numerical Analysis of the Impact of Corrosion on Pipeline Failure Pressure

Dynamic Analysis of Pipeline Lifting Operations for Different Current Velocities and Wave Heights

A study of the ultimate compressive strain of local buckling in strain-based design of pipelines

Safety Test Research of Pressure Pipes Containing Incomplete Welding Defects

Research On Safety Assessment Method For Pressure Pipe With Incomplete Welding Defects Under Complicated Loadings

Stress Analysis of Gas Pipeline in Tunnels on Pressure Testing Condition

Cause Analysis and Improvement Measures for Pipeline Cracking of 9Cr-1Mo Material

Quantitative research on stress failure risk assessment for girth welds with unequal wall thickness of the X80 pipeline under lateral load

Pressure test method of safety assessment on existed submarine pipeline

Surface Stress Analysis of Internally Corroded Pipes under External Pressure

Mechanical study on overbend segment of submarine pipeline during S-Lay

Failure Analysis of Abnormal Bulging and Cracking for High-Pressure Steam Pipe

A New Stress Monitoring Method for Mechanical State of Buried Steel Pipelines under Geological Hazards

3D finite element analysis and optimization of welding residual stress in the girth joints of X80 steel pipeline

Failure Analysis of High-pressure Gas Pipeline Under the Condition of Geologic Hazards

Stress Analysis of the Effect of Additional Load on the Butt Weld of Suspended Pipeline With Variable Wall Thickness

Research on settlement stress detection and control measures for in-service pipelines in valve chamber

Investigation of the tensile strain response of the girth weld of high-strength steel pipeline

Study on Stress Area Law and Detection Range at Key Locations of Natural Gas Station

An Assessment of the Residual Stress of Pipelines Subjected to Localized Large Deformations