Abstract:Film cooling is a commonly used cooling technology in gas turbines, which could reduce heat load by spreading cooling air. However, it faces the problem of stress concentration in structures with holes. The present work focuses on conjugate heat transfer and thermal stress characteristics for a flat film cooling plate through an experimentally validated numerical approach. It discusses the effect of three geometry factors: inclination angle, compound angle, and ellipticity. An engine case simulation and a laboratory case simulation are compared to validate the analogy principle of conjugate heat transfer and thermal stress analysis derived from theoretical analysis. According to the analogy principle, the laboratory flat plate film cooling cases are set to conduct numerical studies. The maximum Mises stress of the film hole is equal to the product of the reference stress and the stress concentration factor. The reference Mises stress is proportional to the overall cooling effectiveness. The stress concentration factor is mainly related to the geometry of the film hole. Reducing the inclination angle of the film hole from 90 degrees to 30 degrees increases the overall cooling effectiveness and drastically increases the stress concentration factor from 2.7 to 5.5. Based on a cylinder hole with a 30 degrees inclination angle, increasing the compound angle enhances the overall cooling effectiveness and slightly increases the stress concentration factor. Based on a cylinder hole with a 30 degrees inclination angle, increasing the ellipticity increases the overall cooling effectiveness and reduces the stress concentration factor. With the increase of ellipticity from 0 to 4, the stress concentration factor decreases from 5.5 to 2. Elliptical film holes are ideal for future low-stress, high-coolingefficiency turbine blades to extend the life of cooling vanes.

A Generalized Thermal Deviation Factor to Evaluate the Comprehensive Stress of Tubes under Non-Uniform Heating

Magneto-Thermo-Elastic Theoretical Solution for Functionally Graded Thick-Walled Tube under Magnetic, Thermal and Mechanical Loads Based on Voigt Method

Effect of Lateral Fin Profiles on Stress Performance of Internally Finned Tubes in a High Temperature Heat Exchanger

Study on Thermal Stress of Water/Steam Solar Absorber Tubes under Unilateral Non-uniform Heat Flux Boundary Conditions

Numerical Research on High Temperature Stress Characteristic of Internally Finned Bayonet Tube

A New Method and Formula for Structure Design and Calculation of Thermal Stress of Finned Tube Used in Industial Boiler

Stress analysis of internally finned bayonet tube in a high temperature heat exchanger

S-CO2 flow in vertical tubes of large-diameter: Experimental evaluation and numerical exploration for heat transfer deterioration and prevention

A New Criterion for Predicting Deterioration of Heat Transfer to Supercritical Water in Smooth Tubes

Numerical Investigation On The Heat Transfer Enhancement Behavior Outside Longitudinal Finned Tubes

Using X-Ray Diffraction and Finite Element Method to Analyze Residual Stress of Tube-to-Tubesheet Welded Joints in a Shell and Tube Heat Exchanger

Thermal-hydraulic-structural Evaluation of S–CO2 Cooling Wall Tubes: A Thermal Stress Evaluating Criterion and Optimization

Remaining Life of Superheater Elbow Tube by Finite Element Method

Computational Analysis of Tube Wall Temperature of Superheater in 1000 MW Ultra-Supercritical Boiler Based on the Inlet Thermal Deviation

Numerical Investigation of Interaction Between Tubes and Loose Supports Caused by Turbulence-Induced Vibration in Steam Generators

Stress analysis of heat exchange tube with inner and outer fins under convection heat transfer conditions

The Analysis and Establish of Thermal Stress Field Model of the Filmed Tubular Electrothermal Component

The Finite Element Simulation and Analysis of Thermal Stress Field of In-Service Tubular Electro-Thermal Component

Numerical Investigation on Flow and Heat Transfer in Heat Transfer Enhancement Fluted Tube

Comprehensive Evaluation on Conjugate Heat Transfer and Thermal Stress Performance of Film Cooling

Transient Thermal Stress and Temperature Change Rate Analysis of Fixed Tubesheet