Abstract:The hot disk transient plane source (TPS) method is a widely used standard technique (ISO 22007-2) for the characterization of thermal properties of materials, especially the thermal conductivity, k. Despite its well-established reliability for a wide variety of common materials, the hot disk TPS method is also known to suffer from a substantial systematic errors when applied to low-k thermal insulation materials. Here, we present a combined numerical and experimental study on the influence of the geometry of hot disk sensor on measured value of low-k materials. We demonstrate that the error is strongly affected by the finite thickness and thermal mass of the sensor's insulation layer was well as the corresponding increase of the effective heater size beyond the radius of the embedded metal heater itself. We also numerically investigate the dependence of the error on the sample thermal properties, confirming that the errors are worse in low-k samples. A simple correction function is also provided, which converts the apparent (erroneous) result from a standard hot disk TPS measurement to a more accurate value. A standard polyimide sensor was also optimized using both wet and dry etching to provide more accurate measurement directly. Experimentally corrected value of k for Airloy x56 aerogel and a commercial silica aerogel using the numerical correction factor derived based on the standard TPS sensor is in excellent agreement with the directly measured value from the TPS sensor using the optimized polyimide sensor. Both of these methods can reduce the errors to less than 4% as compared to around 40% error of overestimation from raw values measured with the pristine sensor. Such results show that both the numerical correction to a pristine senor or an optimized sensor are capable of providing highly accurate value of thermal conductivity for such materials.

Modeling and Accuracy Analysis of Hot Disk Thermal Constants Analyzer

Influence Factors Analysis of Thermal Conductivity Measurement with Hot Disk Technique

Experimental study on measurement accuracy of hot disk thermal constants analyser

Research and verification of thermal model for PCR instrument temperature field

Effects of heat capacity of a Hot disk probe on thermal conductivity measurement

Validation of an analytical model for grinding temperatures in surface grinding by cup wheel with numerical and experimental results

A Numerical Study on the Influence of Insulating Layer of the Hot Disk Sensor on the Thermal Conductivity Measuring Accuracy

Analysis and Improvement of the Hot Disk Transient Plane Source Method for Low Thermal Conductivity Materials

Theoretical Methods and Accuracy Analysis for Extracting Thermophysical Parameters of Thermoelectric Cooling Module

EXPERIMENTAL STUDY OF THERMAL CONDUCTIVITY MEASUREMENT WITH HOTDISK

Assessing the accuracy of mathematical models used in thermoelectric simulation: Thermal influence of insulated air zone and radiation heat

Analysis of errors in the evaluation of parallel transient hot wire measurements by means of line heat source fits

Modeling Analysis and Experimental Study of a Temperature-difference Type Heat Flux Meter

Investigation and Optimization of the Hot Disk Method for Thermal Conductivity Measurements up to 750 °C

Experimental Investigation of High Temperature Thermal Contact Resistance of Thin Disk Samples Using Infrared Camera in Vacuum Condition

The Error Analysis of a Steady-State Thermal Conductivity Measurement Method With Single Constant Temperature Region

The Effect of a Thermal Contact Sensor on the Temperature Distribution and Heat Flux at the Disk Surface

Study on Parameters Correction Method of Steady-State Thermal Model for Spacecraft

The Selection of Key Temperature Measurement Points for Thermal Error Modeling of Heavy-Duty Computer Numerical Control Machine Tools with Density Peaks Clustering

Thermophysical Property Measurement of Thermal Protective Material by Guarded Plane Source Method

Modeling and Estimating Thermal Error in Precision Machine Spindles