Abstract:Thermal conductivity is an important parameter reflecting the heat transfer capacity of soil. In engineering applications , the thermal conductivity of soil varies with influencing factors such as particle size, porosity, water content, saturation, and seepage velocity of soil. At present, the thermal probe method and the traditional thermal response test method are mainly used to determine the thermal conductivity of soil. However, these methods can only perform point temperature measurements and require an inversion calculation based on a particular heat transfer model to obtain the value of soil thermal conductivity. Compared with this and other temperature monitoring methods, optical frequency domain reflectometry (OFDR) offers the advantages of distributed measurement, high measurement accuracy, high spatial resolution, and fast speed. In this paper, an OFDR-based measurement of soil thermal conductivity is designed. Taking sand as an example, the influence of different influencing factors on the measured value of thermal conductivity of soil was studied through the measurement test of thermal conductivity of soil, and the results are compared with the calculation results of the theoretical model of thermal conductivity and the results measured by the thermal probe method. The test results showed that when there was no seepage in the soil, the thermal conductivity of the soil exhibited an "S"-shaped growth trend with increasing water content; when the soil had seepage, the thermal conductivity of the soil was larger than that without seepage, and the thermal conductivity showed a positive linear increase with the increase in seepage velocity; With the increase of heating power, the measurement results tend to be stable. By comparing with the results obtained by other methods, the measurement results of the thermal conductivity measurement method proposed in this study have high accuracy.

EXPERIMENTAL STUDY OF THERMAL CONDUCTIVITY MEASUREMENT WITH HOTDISK

SUPPLEMENTARY EXPERIMENT INVESTIGATION ON THERMAL CONDUCTIVITY MEASURED BY STEADY-STATE PLATE METHOD

Experimental Study on Thermal Conductivity Measurement of Wet Unconsolidated Porous Media

Experimental Study On Heat Transfer Characteristics Of Conductive Plastic Ice-On-Coil

Analysis and Improvement of the Hot Disk Transient Plane Source Method for Low Thermal Conductivity Materials

Investigation and Optimization of the Hot Disk Method for Thermal Conductivity Measurements up to 750 °C

Experimental Investigation of High Temperature Thermal Contact Resistance of Thin Disk Samples Using Infrared Camera in Vacuum Condition

A high-precision method to measure thermal conductivity of solids using reversible heat flux

A simple, accurate, and universal method for characterizing and comparing radiative cooling materials and devices

Experimental Thermal Conductivity Measurement of Hollow-Structured Polypropylene Material by DTC-25 and Hot Box Test

A Micromachined Device Using Transient Hot-Wire Method For High Accuracy Thermal Conductivity Measurement Of Semi-Rigid Materials

A Comparative Study of Computing Methods of Soil Thermal Diffusivity, Temperature and Heat Flux

Short Hot Wire Technique for Measuring Thermal Conductivity and Thermal Diffusivity of Various Materials

DISCUSSION ON THERMAL CONDUCTIVITY MEA- SUREMENTS ON A MICRO-SCALE USING SCANNING THERMAL MICROSCOPE

Principle of Measuring Thermal Conductivity Based on Steady-state Method

Automatic Algorithm Applied for Calculating Thermal Conductivity by Transient Plane Source Method

A study of soil thermal conductivity measurement based on the actively heated distributed temperature sensing cable

Quantitative evaluation of the natural convection effect on thermal conductivity measurement with transient plane source method

Investigation of measurement methods for soil thermal conductivity based on optical frequency domain reflection technology

Building materials thermal conductivity measurement and correlation with heat flow meter, laser flash analysis and TCi

Thermal–physical properties of selected geomaterials: coal, sandstone and concrete based on basic series and parallel models