Abstract:Piezoelectric devices based on high-temperature stable single crystals are of increasing interest due to a wide range of potential applications, such as actuators and resonant gravimetric sensors. The latter require highly accurate resonant-frequency measurements at temperatures as high as 1000 °C, and this can only be achieved with narrow resonance peaks and correspondingly low acoustic loss at these temperatures. Relevant atomistic defects in langasite (La 3 Ga 5 SiO 14 , LGS) and catangasite (Ca 3 TaGa 3 Si 2 O 14 , CTGS) are reviewed with respect to their impact on electrical conductivity and acoustic loss. The focus on these crystals also enables a comparison of electroacoustic properties of partially disordered (LGS) and ordered (CTGS) crystals and the formulation of approaches for reducing acoustic loss and enhancing device performance. Starting with defect chemistry models for LGS and CTGS, electrical conductivities as a function of temperature and oxygen partial pressure are considered. One result of this analysis is that contributions of oxygen ions to the total conductivity are determined to be relatively small in the studied crystals. Temperature-dependent acoustic loss of LGS and CTGS crystals is also studied. Two independent techniques, contact resonant piezoelectric spectroscopy, and a contactless tone-burst excitation technique, are applied. Contributions to the measured acoustic loss are determined by fitting loss-related functions for point defects and conductivity-related relaxations. The extracted fit parameters, in particular the activation energies of the processes, are discussed and compared with that of the electrical conductivity. The losses are caused by a superposition of several mechanisms including conductivity-related relaxations, point-defect relaxations and intrinsic phonon-phonon loss. The long-term stability of the crystals is also evaluated at 1000 °C with respect to fundamental materials properties including electrical conductivity and resonant frequency. After one year of thermal treatment, the resonance frequency of CTGS resonators from different crystal sources is found to decrease by no more than 0.4 %. Thus, the applicability of CTGS as a piezoelectric resonator that operates for long periods at extreme temperatures, such as a resonant nanobalance, is demonstrated. Application examples to be presented include resonant nanobalances for in-situ monitoring of non-stoichiometry and phase transformations in thin films during growth at high temperatures. In this context, the key application properties of the sensors at high temperatures, such as mass sensitivity and resolution, are discussed. As an application example, the attached figure shows the oxygen non-stoichiometry x of thin praseodymium-cerium oxide films (Pr 0.1 Ce 0.9 O 2-x ) at 700 °C as a function of oxygen partial pressure determined by LGS and CTGS nanobalances, which agrees very well with literature data (chemical capacitance: D. Chen et al., Chem. Mater. 2014, 26, 22, 6622–6627). Figure 1

High Temperature Piezoelectric Properties of Yttrium Calcium Oxyborate Single Crystals

Ultra-high Curie Temperature Transparent Piezoelectric Bi Doped Ca2Nb2O7 Single Crystals

Crystal Growth and Characterization of Thulium Calcium Oxyborate High-Temperature Piezoelectric Crystals

Enhancement of the temperature stabilities in yttrium doped (Ba 0.99Ca 0.01)(Ti 0.98Zr 0.02)O 3 ceramics

Growth and Piezoelectric Properties of Large Size ReCa4O(BO3)3 (re=y, Sm) Crystals

High-Temperature Piezoelectrics with Large Piezoelectric Coefficients

Phase structure and electrical properties of (Ba1/2Sr1/2)2+ modified high Curie temperature CaBi2Nb2O9‐based ceramics

Characterization of high temperature piezoelectric crystals with an ordered langasite structure

Piezoelectricity in Excess of 800 pC/N over 400 °C in BiScO 3 –PbTiO 3 –CaTiO 3 Ceramics

A piezoelectric vibration sensor with excellent performance based on Bi12SiO20 crystal for high-temperature applications

Ultra-high Melting Point Ho3+, Yb3+ Co-Doped HfO2 Single-Crystal Fibers for High-Precision and Robust Ratiometric Thermometry Towards Harsh Environments

High Piezoelectric D33 Coefficient in (ba1−xcax)(ti0.98zr0.02)o3 Lead-Free Ceramics with Relative High Curie Temperature

High-Temperature Piezoelectric Resonators: Electroacoustic Properties and Applications of Langasite-Type Crystals

Large strain and temperature-insensitive piezoelectric effect in high-temperature piezoelectric ceramics

Temperature Stability in Dy-Doped (Ba0.99ca0.01)(ti0.98zr0.02)o-3 Lead-Free Ceramics with High Piezoelectric Coefficient

Piezoelectric Properties of BiFeO3 Exposed to High Temperatures

Impact of crystal structure and defect on the electric properties in (LiCeY)-doped CaBi2Nb2O9-based high-temperature piezoceramics

Structure Evolution and Electrical Properties of Y3+‐Doped Ba1−xCaxZr0.07Ti0.93O3 Ceramics

Simultaneously Achieved High Piezoelectricity and Resistivity in CaBi2Nb2O9-based Ceramics with High Curie Temperature

Remarkable temperature-dependent second-harmonic-generation performance of a YCOB crystal

A high temperature stable piezoelectric strain of KNN-based ceramics