Abstract:The most common defect found in the high pressure die casting(HPDC) process is gas porosity which significantly affects the mechanical properties of the final components.As it is known,the air entrapment of the liquid metal flow during the mold filling stage has a close relationship with the gas porosity distribution in die castings.The generation of the entrapped air is mainly due to the interaction between air and liquid metal in the die cavity.In the past few decades,extensive efforts have been made to develop numerical models for the simulation of mold filling.However,these efforts mainly focused on the single phase flow models which can only predict the liquid metal flow and assume that the effect of air in the die cavity is negligible.As a result, these models could not provide the quantity and location of entrapped air in die castings.Recently, several research results on tracking the entrapped air in the molten metal flow have been reported but some techniques still need to be improved further and much more researches are required.In this study,a liquid-gas coupled model is presented to simulate the air entrapment phenomenon during the HPDC mold filling process.The pressure of the entrapped air bubbles is solved at each time step. The calculations of the liquid and gas phases are combined together through the pressure transfer.In order to verify the validity and stability of this model,a specially designed water analog experiment was carried out and compared with the numerical simulation results of the liquid-gas coupled model and the single phase flow model,respectively.The comparison shows that the liquid-gas coupled model has better prediction accuracy than the single phase flow model in tracking the entrapped air bubbles.

Numerical Simulation of Mould Filling in Rheo-Diecasting Process of Semi-Solid Magnesium Alloys

Numerical simulation on semi-solid die-casting of magnesium matrix composite based on orthogonal experiment

Study on Numerical Simulation of Mold Filling and Heat Transfer in Die Casting Process

Numerical Simulation of Fluid Flow and Heat Transfer During Mold Filling for Die Casting

Comparison of Filling Process of A356 Alloy in Semi-solid Thixo-forming Die Casting with in Conventional Die Casting Based on Numerical Simulation with Flow-3D

Determination of casting parameters of thick wall die-casting of magnesium alloy and simulation of its processing

Numerical Simulation of Die-Casting Mold Filling Process Based on Fractional Step Method

Study on numerical simulation of mold-filling and solidification processes of shaped casting

Gating System Design Based on Numerical Simulation and Production Experiment Verification of Aluminum Alloy Bracket Fabricated by Semi-solid Rheo-Die Casting Process

Numerical Simulation and Optimization of Indirect Squeeze Casting Process

Comparison of Rheological Models to Simulate Die Filling Process of A356 Semisolid Alloy

Experimental and simulation study for rewelding defects during the flow process of Semi-solid die casting

Study on Macro- and Micromodeling of the Solidification Process of Aluminum Shape Casting

Study and Application of Cae Simulation in Die-Casting Die Design

Numerical Simulation of Cavity-Filling Procedures for Micro-Pin-fin Array Thixoforming with Semi-Solid A356 Aluminium Alloy

Numerical Simulation and Experimental Investigation of Microstructure Evolution and Flow Behavior in the Rheological Squeeze Casting Process of A356 Alloy

Numerical Simulation of Casting Filling Process of Composites Reinforced with Nano SiC Based on Smoothed Particle Hydrodynamics

Study and Application of Mold Filling Simulation of Shaped Castings

Stress and Distortion Simulation of Magnesium Alloy Die Casting Dies

Numerical Simulation of Air Entrapment Phenomenon During Mold Filling of High Pressure Die Casting Process

Progress on Numerical Simulation of Mold Filling and Solidification Processes of Shaped Castings