Abstract:Scan based built-in self-test (BIST), which naturally extends scan-based test methodology with test patterns applied from test equipment to BIST, can be used for the self test of sequential circuits and attain higher fault coverage. If the circuit under test (CUT) contains multiple parallel scan chains, a parallel generator is needed. Known as the common pseudo-random pattern generator (PRPG), an LFSR can be configured to generate a random pattern stream. The PRPG-based patterns may be applied to the existing scan architecture directly from the LFSR, or through some decorrelation logic. In order to attain higher fault coverage, it is very important to analyze the test pattern generation in the scan based BIST. The paper presents a kind of scheme for test pattern generation in the scan based BIST for the circuits with multiple scan chains. In the test pattern generation scheme the PRPG, which is implemented by an LFSR, shifts the sequences into all scan chains simultaneously. The correlativity weight R(M) of multiple scan chains is also defined in the paper. Based on the analysis of the different degree effect on fault coverage due to the different configuration of multiple scan chains, one conclusion is drawn that the probability that the fault coverage is reduced is increased with an increase of the correlativity weight R(M). If the circuit is tested by the multiple scan chains with the minimum R(M), the probability that the fault coverage is reduced is least. In the paper a method to construct multiple scan chains with minimum correlativity weight R(M) is proposed to overcome the bad effect on fault coverage due to the correlation between scan chains. Furthermore the minimum set of deterministic patterns is generated for hard-to-test faults by ATPG and the set is used to design the bit modifying logic circuit (BML), which is located between multiple scan chains and the CUT. Through BML the signals in multiple scan chains are controlled to input to the CUT. When the test control signal is low, the test patterns in multiple scan chains are input into the CUT directly. When the test control signal is high, the value of the signals at certain bit positions in the multiple scan chains are modified by BML and the changed test patterns are input into the CUT to test hard-to-test faults for complete fault coverage. The experiments on some ISCAS'89 benchmark circuits show that the complete fault coverage can be obtained by the test method presented by the paper. The overhead of BML is also analyzed.

ATPG scan logic failure analysis: a case study of logic ICs – fault isolation, defect mechanism identification and yield improvement

Defect Density Extraction of Gate Oxide Shorts Incorporating Defect Clustering with Pseudo Transistor Arrays

A scan chain optimization method for diagnosis

Pseudo transistor matrix for defect density extraction of gate oxide shorts

Design Time Body Bias Selection for Parametric Yield Improvement.

Diagnosis of Multiple Scan-Chain Faults in the Presence of System Logic Defects

New Techniques for Accelerating Small Delay ATPG and Generating Compact Test Sets

Logic Diagnosis Based on Logic Built-In Self-Test Signatures Collected In-Field from Failing System-on-Chips

Scan Chain Configuration Based X-filling for Low Power and High Quality Testing.

A novel layout automation flow to facilitate test chip design for standard cell characterization

An improved method for test chip design

Achieving Fast Yield Improvement by Defect to Bit Failure Overlay Method

Conflict-driven Structural Learning Towards Higher Coverage Rate in ATPG

Yield-aware Time-Efficient Testing and Self-Fixing Design for TSV-based 3D ICs

A Tool Towards Integration of IC Process, Device, and Circuit Simulation

Multiple Retest Systems for Screening High-Quality Chips

A Novel Scan Segmentation Design for Power Controllability and Reduction in At-Speed Test.

A Comprehensive Test Pattern Generation Approach Exploiting SAT Attack for Logic Locking

Partial Scan Design Based on Circuit State Information

Partial Scan Design Based on Circuit State Information and Functional Analysis

Test Pattern Generation in Built-In Self-Test with Multiple Scan Chains