Abstract:Hollow fiber membranes fabricated via dry/wet phase inversion method usually have two dense skin layers,which will increase its resistance of mass transport as a support membrane. It is necessary that the dense skin layer of support membrane has been eliminated to improve separation performance of composite membrane. The excellent. chemical resistance of poly(vinylidene fluoride) (PVDF) to many acids and alkalis has made it as an attractive membrane material, and then it's often fabricated as porous hollow fiber membrane by phase inversion. In the process, the formation of the skin layer is due to the rapid exchange between solvent and coagulation, so many attempts have been made to slow it, so as to control the formation of the skin layer. In this paper, it has been found that the fabrication progress becomes unstable, and the membrane prepared has noncircular lumen, when the "weak" or "soft" coagulation is used. To increase the fabrication solution stability during membrane formation, dope viscosity was focused in this experiment. Dimethyl acetamide (DMAc) was used as solvent as well as internal coagulant, and the additives including LiCl, water and surfactant Span were chosen to investigate their effect oil the viscosity of the fabrication solution. The dope viscosity will greatly increase after adding LiCl, while the variety of dope viscosity is unconcerned in the fabrication solution concentration as adding water. The homogenization and stability of the fabrication solution are improved by adding Span,and the viscosity increases at the same time. Without increasing PVDF concentration, the stability of the nascent membrane was improved by increasing the fabrication viscosity. The PVDF hollow fiber membrane with the structure of single outer skin layer and finger-like pore through the cross-section, has been successfully fabricated. The mean pore radius and water flux of the single skin hollow fiber membrane were greatly improved.

Rheological Behavior of Spinning Solution System (PVDF/TEP/Al2O3) for Hollow Fiber Membrane

Effect of solvent concentration on development of macrovoids of PVDF phase-diversion membranes

The Polymer-rich Phase Solidification Process of PVDF-PVP-DMAc-H2O Solution

Structure formation and characterization of PVDF hollow fiber membranes by melt-spinning and stretching method

Fabrication of Hydrophilic and Sponge-Like PVDF/brush-like Copolymer Blend Membranes Using Triethylphosphate As Solvent

Influence of additives on phase separation process of PVDF solution and membrane morphology

Preparation and Characterization of Poly(vinylidene Fluoride) Flat Sheet Membrane with Tg Tunable Amphiphilic Terpolymer As Membrane Additive

Effect of Additives on the Morphology and Performance of Symmetric Network PVDF Membranes

Influence of Dope Viscosity on the Fabrication of Pvdf Hollow Fiber Membranes with Single Skin Layer

Controlling the Morphology and Crystal Form of Symmetric Network PVDF Membranes by Bath Temperature

Effect of Polymer Molecular Weight on the Morphology and Crystallization of Prepared PVDF Membranes

Effect of the molecular weight and its distribution of polyvinylidene fluoride on the relationship between the spinning process, microstructure and properties of hollow fiber membranes via thermally induced phase separation

Study on the Rheological Properties of Fluorinated Polyimide Spinning Solution

Dry–wet spinning of temperature-sensitive PVDF hollow-fiber membranes at different bore fluid flow rates

RHEOLOGICAL PROPERTIES OF POLY(VINYLIDENE FLUORIDE) MELT

Influence of TM Additive on Structure and Performance of PVDF/PHEMA Alloy Microfiltration Membrane

Rheological Properties of Poly(Vinylidene Fluoride) in Molten State

Effect of Polymer Content on the Properties of PVDF Electro-spinning Nanofiber Membrane for Membrane Distillation

Fabrication and Property Optimization of Electrostatic Spinning PVDF/PDMS Waterproof and Moisture Permeable Membrane

Rheological behavior of blend spinning solution of sodium alginate and carbon black

A Comprehensive Study on the Rheological Properties of Collagen/PVA Spinning Solutions from Acetic Acid Solvent