Abstract:Hollow fiber membranes fabricated via dry/wet phase inversion method usually have two dense skin layers,which will increase its resistance of mass transport as a support membrane. It is necessary that the dense skin layer of support membrane has been eliminated to improve separation performance of composite membrane. The excellent. chemical resistance of poly(vinylidene fluoride) (PVDF) to many acids and alkalis has made it as an attractive membrane material, and then it's often fabricated as porous hollow fiber membrane by phase inversion. In the process, the formation of the skin layer is due to the rapid exchange between solvent and coagulation, so many attempts have been made to slow it, so as to control the formation of the skin layer. In this paper, it has been found that the fabrication progress becomes unstable, and the membrane prepared has noncircular lumen, when the "weak" or "soft" coagulation is used. To increase the fabrication solution stability during membrane formation, dope viscosity was focused in this experiment. Dimethyl acetamide (DMAc) was used as solvent as well as internal coagulant, and the additives including LiCl, water and surfactant Span were chosen to investigate their effect oil the viscosity of the fabrication solution. The dope viscosity will greatly increase after adding LiCl, while the variety of dope viscosity is unconcerned in the fabrication solution concentration as adding water. The homogenization and stability of the fabrication solution are improved by adding Span,and the viscosity increases at the same time. Without increasing PVDF concentration, the stability of the nascent membrane was improved by increasing the fabrication viscosity. The PVDF hollow fiber membrane with the structure of single outer skin layer and finger-like pore through the cross-section, has been successfully fabricated. The mean pore radius and water flux of the single skin hollow fiber membrane were greatly improved.

Effect of Polymer Content on the Properties of PVDF Electro-spinning Nanofiber Membrane for Membrane Distillation

Preparation and Characterization of PVDF/nonwoven Fabric Flat-Sheet Composite Membranes for Desalination Through Direct Contact Membrane Distillation

Effect of Spinning Conditions on the Structure and Performance of Hydrophobic PVDF Hollow Fiber Membranes for Membrane Distillation

Effect of the Permeants/Polymer Interactions on the Pervaporative Separation Properties of the P(Vdf-Co-Hfp) Membrane

Polyamide/PVC Based Composite Hollow Fiber Nanofiltration Membranes: Effect of Substrate on Properties and Performance

Fabrication of polyvinylidene fluoride (PVDF) nanofiber membranes by electro-spinning for direct contact membrane distillation

Preparation of Superhydrophobic PVDF Nanofiber Membranes for Membrane Distillation and Study on Its Performance

Influence of Dope Viscosity on the Fabrication of Pvdf Hollow Fiber Membranes with Single Skin Layer

Effect of mixed additives on structure and performance of PVDF flat sheet hydrophobic membrane

Beaded electrospun polyvinylidene fluoride (PVDF) membranes for membrane distillation (MD)

Effect of Dissolving Temperature of Dopes on the Morphology of PVDF Membrane

EFFECTS OF POLYMER MOLECULAR WEIGHT ON PVDF MICROFILTRATION MEMBRANE PERFORMANCE BY IMMERSION PRECIPITATION PHASE INVERSION

Morphology and Formation Mechanism of Poly(Vinylidene Fluoride) Membranes Prepared with Immerse Precipitation: Effect of Dissolving Temperature

Effect of Additives on the Morphology and Performance of Symmetric Network PVDF Membranes

PREPARATION AND PERFORMANCE OF PVDF MEMBRANES FABRICATED BY PVDF-SOLVENT-NON-SOLVENT-ADDTIVE SYSTEMS

Electrospun Poly (Vinylidene Fluoride-Co-Hexafluoropropylene) Nanofiber Membranes for Brine Treatment via Membrane Distillation

Experimental Investigation of the Effect of Electrospinning Parameters on Properties of Superhydrophobic PDMS/PMMA Membrane and Its Application in Membrane Distillation

Effects of calcium carbonate nano-particles on the properties of PVDF/nonwoven fabric flat-sheet composite membranes for direct contact membrane distillation

Microstructures and Properties of PVDF Membranes: Effect of the Solvent

Effect of the molecular weight and its distribution of polyvinylidene fluoride on the relationship between the spinning process, microstructure and properties of hollow fiber membranes via thermally induced phase separation

PVDF hollow fiber and nanofiber membranes for fresh water reclamation using membrane distillation