Abstract:Decomposition characteristics of two groups of representative mixed malodorants (1, ethanethiol + hydrogen sulfide; 2, ethanethiol + ammonia) in air were investigated employing a wire-plate pulse Corona reactor. A new type of high-voltage pulse generator with a thyratron switch and a Blumlein pulse-forming network (BPFN) was used in our experiments. The experiments were conducted at a gas-flow rate of, 13 m(3)/h. Important parameters, including peak voltage, chemical structures of malodorants, pulse frequency, and initial concentration, which influenced the removal efficiency, were investigated. The results showed that the mixed malodorants could be treated effectively by pulse Corona. The removal efficiencies of 200 mg/m(3) C2H5SH and 200 mg/m(3) H2S for group I were 95.6% and 100%, respectively, which were almost equal to those of the two pollutants separately. The energy cost was about 65.1-81.4 A, which was 31.5-45.2% lower than for treating pollutants alone. The removal efficiencies of 105 mg/m(3) C2H5SH and 40 mg/m3 NH3 for group 2 were 93.1% and almost 100%, and the energy cost was 65.1 J/L, 55.6% lower than that which was treated separately. In the case of two groups of mixed malodorants removal, NO,, O-3, SO2, CO2, and CO were all observed. Moreover, some sulfur and white crystal ammonium nitrates were discovered adhering to the Corona wires in the removal of groups 1 and 2, respectively. A dynamics model was developed to describe the relation of the removal efficiency with specific energy density and initial concentration. In the case of group 1 removal,the decomposition rate constants decreased as compared to the single treating. As for group 2 removal, the decomposition rate constants increased, especially for NH3. According to the results, the optimization design for the reactor and the matching of high pulse voltage source can be reckoned.

Decomposition of Simulated Odors in Municipal Wastewater Treatment Plants by a Wire-Plate Pulse Corona Reactor.

Decomposition of mixed malodorants in a wire-plate pulse corona reactor.

Decomposition of Dimethyl Sulfide in a Wire-Cylinder Pulse Corona Reactor

Wipe out of Stench from Landfill Leachate by Non-Thermal Plasma Combined with Blow-off

Abatement of Malodorants from Pesticide Factory in Dielectric Barrier Discharges.

Study on ozone generation from H2S and NH3 removal by pulsed corona discharge

Experimental Study on Volatile Sulfur Compound Inhibition Using a Single-Chamber Membrane-Free Microbial Electrolysis Cell

Removal of Dilute VOCs in Air by Post-Plasma Catalysis over Ag-based Composite Oxide Catalysts

Degradation of Aqueous Rhodamine B with Gaseous Streamer Corona Plasma

A Pilot Investigation on Oxidation of Ammonium Sulfite by Streamer Corona Plasma

Evaluation of Multiple Corona Reactor Modes and the Application in Odor Removal

Scale-up Experiment of Plasma Reactors with Different Electrode Structure

Effect of the Rapid Increase of Salinity on Anoxic-Oxic Biofilm Reactor for Treatment of High-Salt and High-Ammonia-nitrogen Wastewater.

[Scale-Up Study on Pulse Corona Discharge for the Removal of Toluene].

Combination Of Non-Thermal Plasma And Activated Carbon Fibers For Decomposition Of Hydrogen Sulfide

Scale-up investigation on pulse corona for the removal of toluene

Influence of balance gas mixture on decomposition of dimethyl sulfide in a wire-cylinder pulse corona reactor.

Novel Multineedle-to-cylinder Plasma Coupled with Bimetallic Catalysts for Efficient Removal of Sulfides and Ammonia in Odor Gases

Simultaneous Treatment of Various Malodorous Substances in Gas by Non-Thermal Plasma

A combined process of non-thermal plasma with sludge stabilization for the simultaneous reduction of odor and organic waste

Phenol degradation by a hybrid gas-liquid discharge reactor with digital-analog mixed control