Abstract:Decomposition characteristics of two groups of representative mixed malodorants (1, ethanethiol + hydrogen sulfide; 2, ethanethiol + ammonia) in air were investigated employing a wire-plate pulse Corona reactor. A new type of high-voltage pulse generator with a thyratron switch and a Blumlein pulse-forming network (BPFN) was used in our experiments. The experiments were conducted at a gas-flow rate of, 13 m(3)/h. Important parameters, including peak voltage, chemical structures of malodorants, pulse frequency, and initial concentration, which influenced the removal efficiency, were investigated. The results showed that the mixed malodorants could be treated effectively by pulse Corona. The removal efficiencies of 200 mg/m(3) C2H5SH and 200 mg/m(3) H2S for group I were 95.6% and 100%, respectively, which were almost equal to those of the two pollutants separately. The energy cost was about 65.1-81.4 A, which was 31.5-45.2% lower than for treating pollutants alone. The removal efficiencies of 105 mg/m(3) C2H5SH and 40 mg/m3 NH3 for group 2 were 93.1% and almost 100%, and the energy cost was 65.1 J/L, 55.6% lower than that which was treated separately. In the case of two groups of mixed malodorants removal, NO,, O-3, SO2, CO2, and CO were all observed. Moreover, some sulfur and white crystal ammonium nitrates were discovered adhering to the Corona wires in the removal of groups 1 and 2, respectively. A dynamics model was developed to describe the relation of the removal efficiency with specific energy density and initial concentration. In the case of group 1 removal,the decomposition rate constants decreased as compared to the single treating. As for group 2 removal, the decomposition rate constants increased, especially for NH3. According to the results, the optimization design for the reactor and the matching of high pulse voltage source can be reckoned.

Novel Multineedle-to-cylinder Plasma Coupled with Bimetallic Catalysts for Efficient Removal of Sulfides and Ammonia in Odor Gases

Energy efficiency optimization for H2S removal by dielectric barrier discharge plasma

Removal of Dilute VOCs in Air by Post-Plasma Catalysis over Ag-based Composite Oxide Catalysts

Characteristics of Back Corona Discharge in a Honeycomb Catalyst and Its Application for Treatment of Volatile Organic Compounds.

Streamer Plasma Induced Ammonia Flue Gas Desulfurization

Simultaneous Treatment of Various Malodorous Substances in Gas by Non-Thermal Plasma

Decomposition of mixed malodorants in a wire-plate pulse corona reactor.

Abatement of Malodorants from Pesticide Factory in Dielectric Barrier Discharges.

Decomposition of Dimethyl Sulfide in a Wire-Cylinder Pulse Corona Reactor

Removal of Hydrogen Sulfide in Biogas by DBD Plasma

Application of Non-Thermal Plasma Technology on Fugitive Methane Destruction: Configuration and Optimization of Double Dielectric Barrier Discharge Reactor

Decomposition of ammonia and hydrogen sulfide in simulated sludge drying waste gas by a novel non-thermal plasma.

Successive treatment of benzene and derived byproducts by a novel plasma catalysis-adsorption process

Removal of ammonia from gas streams with dielectric barrier discharge plasmas

Removal of chlorobenzene over LaMnO3 and OMS-2 catalysts in a dielectric barrier discharge reactor

Degradation of chlorinated volatile organic compounds in waste gas by catalytic plasma system

Deodorization of dimethyl sulfide using a discharge approach at room temperature

Removal of dimethyl sulfide by post-plasma catalysis over CeO2-MnO catalysts and reaction mechanism analysis

Dual-course Dielectric Barrier Discharge with a Novel Hollow Micro-Holes Electrode to Efficiently Mitigate NOx

A Core-Shell Structured Crystalline@amorphous MnO2 with Enhanced Plasma Catalytic Degradation Performance for Volatile Organic Sulfur Compounds and Degradation Mechanism Exploration

Decomposition of Simulated Odors in Municipal Wastewater Treatment Plants by a Wire-Plate Pulse Corona Reactor.