Abstract:Decomposition characteristics of two groups of representative mixed malodorants (1, ethanethiol + hydrogen sulfide; 2, ethanethiol + ammonia) in air were investigated employing a wire-plate pulse Corona reactor. A new type of high-voltage pulse generator with a thyratron switch and a Blumlein pulse-forming network (BPFN) was used in our experiments. The experiments were conducted at a gas-flow rate of, 13 m(3)/h. Important parameters, including peak voltage, chemical structures of malodorants, pulse frequency, and initial concentration, which influenced the removal efficiency, were investigated. The results showed that the mixed malodorants could be treated effectively by pulse Corona. The removal efficiencies of 200 mg/m(3) C2H5SH and 200 mg/m(3) H2S for group I were 95.6% and 100%, respectively, which were almost equal to those of the two pollutants separately. The energy cost was about 65.1-81.4 A, which was 31.5-45.2% lower than for treating pollutants alone. The removal efficiencies of 105 mg/m(3) C2H5SH and 40 mg/m3 NH3 for group 2 were 93.1% and almost 100%, and the energy cost was 65.1 J/L, 55.6% lower than that which was treated separately. In the case of two groups of mixed malodorants removal, NO,, O-3, SO2, CO2, and CO were all observed. Moreover, some sulfur and white crystal ammonium nitrates were discovered adhering to the Corona wires in the removal of groups 1 and 2, respectively. A dynamics model was developed to describe the relation of the removal efficiency with specific energy density and initial concentration. In the case of group 1 removal,the decomposition rate constants decreased as compared to the single treating. As for group 2 removal, the decomposition rate constants increased, especially for NH3. According to the results, the optimization design for the reactor and the matching of high pulse voltage source can be reckoned.

Influence of balance gas mixture on decomposition of dimethyl sulfide in a wire-cylinder pulse corona reactor.

Humidity and Oxygen Effects on Dimethyl Sulfide Decomposition Plasma Corona Reactor

Decomposition of Dimethyl Sulfide in a Wire-Cylinder Pulse Corona Reactor

Decomposition of Dimethyl Sulfide in Dielectric Barrier Plasma Discharge Assisted by Active Carbon

Energy efficiency optimization for H2S removal by dielectric barrier discharge plasma

Decomposition of Dimethyl Sulfide with Non-Thermal Plasma Induced by Dielectric Barrier Discharge

Decomposition of mixed malodorants in a wire-plate pulse corona reactor.

Combination Of Non-Thermal Plasma And Activated Carbon Fibers For Decomposition Of Hydrogen Sulfide

Removal of Dilute VOCs in Air by Post-Plasma Catalysis over Ag-based Composite Oxide Catalysts

Abatement of Malodorants from Pesticide Factory in Dielectric Barrier Discharges.

Deodorization of dimethyl sulfide using a discharge approach at room temperature

Destruction of Dimethyl Disulfide in a Gas Flow System with Dielectric Barrier Discharge

[Scale-Up Study on Pulse Corona Discharge for the Removal of Toluene].

Analysis of Decomposition By-Products and Its Formation Mechanism of SF6/N2 Mixed Gases under Spark Discharge

Study on ozone generation from H2S and NH3 removal by pulsed corona discharge

Scale-up Experiment of Plasma Reactors with Different Electrode Structure

DBD Plasma Combined with Different Foam Metal Electrodes for CO2 Decomposition: Experimental Results and DFT Validations

Wire-tube DBD reactor for H2S treatment: optimization of geometric and electrical parameters

Investigation of Dry Reforming of Methane in a Dielectric Barrier Discharge Reactor

High Concentration Xylene Decomposition and Diagnostic Analysis by Non-Thermal Plasma in A Dbd Reactor

Decomposition of Simulated Odors in Municipal Wastewater Treatment Plants by a Wire-Plate Pulse Corona Reactor.