Abstract:Decomposition characteristics of two groups of representative mixed malodorants (1, ethanethiol + hydrogen sulfide; 2, ethanethiol + ammonia) in air were investigated employing a wire-plate pulse Corona reactor. A new type of high-voltage pulse generator with a thyratron switch and a Blumlein pulse-forming network (BPFN) was used in our experiments. The experiments were conducted at a gas-flow rate of, 13 m(3)/h. Important parameters, including peak voltage, chemical structures of malodorants, pulse frequency, and initial concentration, which influenced the removal efficiency, were investigated. The results showed that the mixed malodorants could be treated effectively by pulse Corona. The removal efficiencies of 200 mg/m(3) C2H5SH and 200 mg/m(3) H2S for group I were 95.6% and 100%, respectively, which were almost equal to those of the two pollutants separately. The energy cost was about 65.1-81.4 A, which was 31.5-45.2% lower than for treating pollutants alone. The removal efficiencies of 105 mg/m(3) C2H5SH and 40 mg/m3 NH3 for group 2 were 93.1% and almost 100%, and the energy cost was 65.1 J/L, 55.6% lower than that which was treated separately. In the case of two groups of mixed malodorants removal, NO,, O-3, SO2, CO2, and CO were all observed. Moreover, some sulfur and white crystal ammonium nitrates were discovered adhering to the Corona wires in the removal of groups 1 and 2, respectively. A dynamics model was developed to describe the relation of the removal efficiency with specific energy density and initial concentration. In the case of group 1 removal,the decomposition rate constants decreased as compared to the single treating. As for group 2 removal, the decomposition rate constants increased, especially for NH3. According to the results, the optimization design for the reactor and the matching of high pulse voltage source can be reckoned.

Combination Of Non-Thermal Plasma And Activated Carbon Fibers For Decomposition Of Hydrogen Sulfide

Electrochemical Removal of Hydrogen Sulfide and Recovery of the Deposited Sulfur on the Anode from Wastewater

Two-stage System of Non-Thermal Plasma and Adsorption for Decomposition of Hydrogen Sulfide

Removal of Dilute VOCs in Air by Post-Plasma Catalysis over Ag-based Composite Oxide Catalysts

Elimination of Sulphur Odours at Landfills by Bioconversion and the Corona Discharge Plasma Technique

Decomposition of Dimethyl Sulfide in a Wire-Cylinder Pulse Corona Reactor

Humidity and Oxygen Effects on Dimethyl Sulfide Decomposition Plasma Corona Reactor

Reaction mechanism in desulfurization of flue gas by low temperature plasma

Decomposition of Dimethyl Sulfide in Dielectric Barrier Plasma Discharge Assisted by Active Carbon

Study on ozone generation from H2S and NH3 removal by pulsed corona discharge

DEGRADATION OF HYDROGEN SULFIDE USING NON-THERMAL PLASMA AND OZONE CATALYTIC OXIDATION

Energy Efficiency in Hydrogen Sulfide Removal by Non-Thermal Plasma Photolysis Technique at Atmospheric Pressure

Influence of balance gas mixture on decomposition of dimethyl sulfide in a wire-cylinder pulse corona reactor.

Removal of H2S from Gas Stream Using Combined Plasma Photolysis Technique at Atmospheric Pressure

Destruction of H2s Gas with A Combined Plasma Photolysis (cpp) Reactor

Sludge Treatment by O-3/H2o2 and Carbon Source Recovery

Simultaneous Treatment of Various Malodorous Substances in Gas by Non-Thermal Plasma

Decomposition of ammonia and hydrogen sulfide in simulated sludge drying waste gas by a novel non-thermal plasma.

Decomposition of mixed malodorants in a wire-plate pulse corona reactor.

A combined process of non-thermal plasma with sludge stabilization for the simultaneous reduction of odor and organic waste

Decomposition of CO2 Using Pulsed Corona Discharges Combined with Catalyst