Abstract:The SO2/NOX pollution in the flue gas of non-ferrous smelting is increasingly serious. At the same time, the accumulation of red mud (RM) in the aluminum industry and phosphorus sludge (PS) in the yellow phosphorus industry has caused serious harm to the environment. To remove SO2 and NOX from the non-ferrous smelting flue gas and realize the resource utilization of the above two solid wastes, an ultrasonic field was used in this study to strengthen the PS excited O3 process and RM wet desulfurization and denitrification process. In the process of O3 excitation, the response surface method (RSM) is used to obtain the optimal O3 excitation concentration, and the optimal reaction conditions are designed based on the response surface optimization model: T is 53.226 °C, power density is 0.4 W/cm2, PS concentration is 51.433 g/L, O3 formation concentration up to 250 ppm or more, which provides a theoretical basis for subsequent desulfurization and denitrification steps. It is proved that this study can replace the expensive traditional O3 generator and provide a basis for NOX removal in the following process. In addition, the optimum experimental conditions of ultrasonic enhanced RM desulfurization and denitrification process were also explored. Under ultrasonic frequency of 28 kHz, ultrasonic power density of 0.4 W/cm2, T of 50 °C, RM concentration of 15 g/L, and stirring intensity of 1000 rpm, the desulfurization efficiency of the reaction system can be maintained above 95 % within 250 min, and the denitrification efficiency can be maintained above 90 % within 250 min. The effect of desulfurization and denitrification in this study is much better than that of traditional methods. Finally, the reaction mechanism of ultrasonic enhanced O3 excitation and RM wet desulfurization and nitrogen removal was discussed by combining adsorption thermodynamics, isotherm, and kinetics. The results showed that the OH· free radicals generated by ultrasonic cavitation and the physical effects brought by emulsification had significant promoting effects.

DEGRADATION OF HYDROGEN SULFIDE USING NON-THERMAL PLASMA AND OZONE CATALYTIC OXIDATION

Combination Of Non-Thermal Plasma And Activated Carbon Fibers For Decomposition Of Hydrogen Sulfide

Removal of Dilute VOCs in Air by Post-Plasma Catalysis over Ag-based Composite Oxide Catalysts

Sludge Treatment by O-3/H2o2 and Carbon Source Recovery

Two-stage System of Non-Thermal Plasma and Adsorption for Decomposition of Hydrogen Sulfide

Simultaneous Treatment of Various Malodorous Substances in Gas by Non-Thermal Plasma

Study on ozone generation from H2S and NH3 removal by pulsed corona discharge

Removal of Hydrogen Sulfide in Biogas by DBD Plasma

Ultrasonic-enhanced Phosphorus Sludge Excited O3 Coupled Red Mud Simultaneous Desulfurization and Denitrification

Removal Characteristics of Gaseous Sulfur-Containing Compounds by Pulsed Corona Plasma

Catalytic Degradation of 1,2-Chlorobenzene and Dioxins Coupled by Kinds of Methods

An efficient treatment for degradation of high-concentration xylene gas via water falling film discharge in synergy with silver catalysis

A combined process of non-thermal plasma with sludge stabilization for the simultaneous reduction of odor and organic waste

Efficient Degradation of H2S over Transition Metal Modified TiO2 under VUV Irradiation: Performance and Mechanism

Simulation and experimental study on the degradation of the greenhouse gas SF6 by thermal plasma

KINETIC MODELING OF HYDROGEN SULFIDE REMOVAL BY OZONE OXIDATION

Abatement of chlorobenzene by plasma catalysis: Parameters optimization through response surface methodology (RSM), degradation mechanism and PCDD/Fs formation

Progress on hydrogen sulfide removal: From catalytic oxidation to plasma-assisted treatment

The Simultaneous Catalytic Removal of VOCs and O3 in a Post-Plasma

Study on the degradation of VOCs in a plasma-catalyst hybrid reactor

A Study on the Efficient Degradation of Sulfur Hexafluoride by Pulsed Dielectric Barrier Discharge Synergistic Active Gas