Abstract:Thin‐film rechargeable lithium batteries with amorphous and crystalline LiCoO2 cathodes were investigated. The lithium cobalt oxide films were deposited by radio‐frequency (RF) magnetron sputtering of an LiCoO2 target in a 3:1 Ar/ O2 mixture gas. From proton‐induced γ‐ray emission analysis (PIGE) and Rutherford backscattering spectrometry (RBS), the average composition of these films was determined to be Li1.15CoO2.16 or, within experimental uncertainty, LiCoO2+0.08 Li2O . The x‐ray powder diffraction patterns of films annealed in air at 500 to 700°C were consistent with the regular hexagonal structure observed for crystalline LiCoO2 . The discharge curves of the cells with amorphous LiCoO2 cathodes showed no obvious structural transition between 4.2 and 2.0 V, while the discharge curves of the cells with polycrystalline cathodes were consistent with a two‐phase potential plateau at ∼3.9 V with a relatively large capacity. Two lower capacity plateaus were observed at ∼4.2 and 4.1 V with the 600 and 700°C annealed cathodes; the −dq/dV peaks were broader and weaker for the 600°C annealed cathodes and were not present at all with the 500°C annealed films. The chemical diffusion coefficients of Li+ in the cathodes obtained from ac impedance measurements at cell potentials of ∼4V ranged from ∼10−12 cm2/s for the as‐deposited amorphous cathodes to ∼10−9 cm2/s for the films annealed at 700°C. The capacity loss on extended cycling of the thin‐film cells varied with the crystallinity and thickness of the cathodes and with temperature. With the highly crystalline, 700°C annealed material, losses on cycling between 4.2 and 3.8 V at 25°C ranged from 0.0001%/cycle (>104 cycles) to 0.002%/cycle for cells with cathodes from 0.05 to 0.5 μm thick.

Physical and Electrochemical Characterization of LiCo0.8M0.2O2 (m=ni,zr) Cathode Films for All-solid-state Rechargeable Thin-film Lithium Batteries

Preparation and Electrochemical Properties of Li[Ni1/3Co1/3Mn1−x/3Zrx/3]O2 Cathode Materials for Li-ion Batteries

Cathode Materials of Li_xCo_(0.8)Ni_(0.2)O_2 for Lithium-ion Battery

All-Solid-State Thin Film Lithium Batteries With Licoo2 Cathodes

All-Solid-State Rechargeable Thin Film Lithium Batteries With Lixmn2o4 And Lixmn2o4-0.5zro(2) Cathodes

Layered Li(Ni[sub 1/4]mn[sub 1/2]co[sub 13])o[sub 2] As Cathode Material for All-Solid-State Thin-Film Rechargeable Lithium-Ion Batteries

Investigation on performance of Li(Ni 0.5 Co 0.2 Mn 0.3 ) 1−x Ti x O 2 cathode materials for lithium-ion battery

Synthesis and electrochemical performance of LiNi_(1/3)Mn_(1/3)Co_(1/3)O_2-zFz cathode materials for lithium ion batteries

Characterization of Thin‐Film Rechargeable Lithium Batteries with Lithium Cobalt Oxide Cathodes

Synthesis and Characterization of M-doped Li1.05Co0.3Ni0.35Mn0.3O2 (M=Zn, Fe, Ti, Zr) Cathode Materials for Lithium ion Battery

Fabrication and interfacial characterization of Ni-rich thin-film cathodes for stable Li-ion batteries

A nanocrystalline Co3O4 thin film electrode for Li-ion batteries

LiNbO3 Coating and F- Doping Stabilize the Crystal Structure and Ameliorate the Interface of LiNi0.88Co0.06Mn0.03Al0.03O2 to Improve the Electrochemical Properties and Safety Capability

An amorphous LiCo1/3Mn1/3Ni1/3O2 thin film deposited on NASICON-type electrolyte for all-solid-state Li-ion batteries

Al, B, and F doped LiNi1/3Co1/3Mn1/3O2 as cathode material of lithium-ion batteries

Synthesis And Characterization Of Li(Li0.2mn0.4fe0.2m0.2)O-2 (M=Co, Ni, Cr, Al) Cathode Materials For Li-Ion Batteries

Cathode Materials of LixCo0. 8Ni0. 2O2 for Lithium-ion Battery

Stable nanostructured cathode with polycrystalline Li-deficient Li 0.28Co0.29Ni0.30Mn0.20O2 for lithium-ion batteries

Enhanced electrochemical properties and thermal stability of Zr4+ doped Li1.20Mn0.54Ni0.13Co0.13O2 cathode material by a Li ion conductor of Li3PO4 surface coating

Preparation and Electrochemical Properties of LiNi<sub>2/3</sub>Co<sub>1/6</sub>Mn<sub>1/6</sub>O<sub>2</sub> Cathode Material for Lithium-Ion Batteries

Microstructure and electrochemical properties of LiNi1/3Co1/3Mn1/3O2 coated with a12o3 film