Abstract:Multiple ion-doped lithium manganese oxides LiCr x Ni x Mn 2-2x O 4-z F z (0 < x ≤ 0.25, z = 0.05, 0.1) with a spinel structure and space group Fd 3 m were prepared by using the co-precipitation procedure carried out in water–alcohol solvent using adipic acid as the chelating agent. The electrochemical measurements indicated that the charge/discharge capacities of the samples prepared at 600 °C are higher than that of the treatment at 800 °C or microwave heating. The capacitance-voltage (CV) curves of LiCr x Ni x Mn 2-2x O 4-z F z (0 < x ≤ 0.25, z = 0.05, 0.1) showed that when x ≤ 0.1, the samples had two reduction–oxidation peaks at 4.0 to 4.2-V region, whereas when x > 0.1, the samples had only one reduction–oxidation peak at 4.0- to 4.2-V region in CV measurements and could offer more stable voltage plateau in a 4-V region and also had stable electrical conductivity after 20 cycles. Another reduction–oxidation peak appeared in 4.6-4.8-V region (Ni 2+ –Ni 4+ reduction–oxidation peaks); this suggests that the LiCr x Ni x Mn 2-2x O 4-z F z (0.1 < x ≤ 0.25, z = 0.05, 0.1) cathode material could offer 4.6 to 4.8-V charge/discharge plateaus, and its specific capacity increases with increasing Ni 2+ . The impedance measurements of the cell proved that the F − anion doped can not only prevent Mn 3+ from disproportion but also can prevent the passivation film from forming and can help keep stable the cell’s electrical properties. The LiCr 0.05 Ni 0.05 Mn 1.9 O 3.9 F 0.1 sintered at 600 °C shows the best cycle performance and the largest capacity in all prepared samples; its first discharge capacity is 120 mAh/g, and the discharge capacity loses only 1.78

Synthesis and electrochemical performance of LiNi_(1/3)Mn_(1/3)Co_(1/3)O_2-zFz cathode materials for lithium ion batteries

Preparation and Electrochemical Properties of Li[Ni1/3Co1/3Mn1−x/3Zrx/3]O2 Cathode Materials for Li-ion Batteries

A cation/anion co-doped Li1.12Na0.08Ni0.2Mn0.6O1.95F0.05 cathode for lithium ion batteries

Enhanced electrochemical performance of F-doped Li<sub>1.2</sub>Mn<sub>4/6</sub>Ni<sub>1/6</sub>Co<sub>1/6</sub>O<sub>2.35</sub> cathode materials for Li-ion batteries

Enhanced electrochemical performance of Li 1.2 Mn 0.54 Ni 0.13 Co 0.13 O 2 cathode material coated with Li + -conductive Li 2 SiO 3 for lithium ion batteries

Heightening the long cycling stability and reducing oxygen loss of Li-rich cathode materials by Mo–F Co-doping for half/full lithium-ion batteries

Enhanced Electrochemical Performance of F-doped Li1.2Mn4/6Ni1/6Co1/6O2.35 Cathode Materials for Li-ion Batteries

Effect of Cationic (Na+) and Anionic (F−) Co-Doping on the Structural and Electrochemical Properties of LiNi1/3Mn1/3Co1/3O2 Cathode Material for Lithium-Ion Batteries

Improving the Electrochemical Properties of High-Energy Cathode Material Lini0.5co0.2mn0.3o2 by Zr Doping and Sintering in Oxygen

Co-precipitation synthesis and performance of multi-doped LiCr x Ni x Mn 2-2x O 4-z F z cathode materials for lithium ion batteries

Improving the single crystal LiNi0.8Co0.1Mn0.1O2 cathode material performance by fluorine doping

Advanced Electrochemical Performance of Li[Ni(1/3−x)FexCo1/3Mn1/3]O2 As Cathode Materials for Lithium-Ion Battery

LiNbO3 Coating and F- Doping Stabilize the Crystal Structure and Ameliorate the Interface of LiNi0.88Co0.06Mn0.03Al0.03O2 to Improve the Electrochemical Properties and Safety Capability

Electrochemical Performance of Li-rich Cathode Material, 0.3li2mno3–0.7limn1/3ni1/3co1/3o2 Microspheres with F-doping

Al, B, and F doped LiNi1/3Co1/3Mn1/3O2 as cathode material of lithium-ion batteries

Synthesis of LiNi1/3Co1/3Mn1/3O2-zFz cathode material from oxalate precursors for lithium ion battery

Synthesis and Characterization of M-doped Li1.05Co0.3Ni0.35Mn0.3O2 (M=Zn, Fe, Ti, Zr) Cathode Materials for Lithium ion Battery

Synthesis, Characterization and Electrochemical Performance of Li[Li0.2Mn0.54Ni0.13Co0.13]O2cathode Materials for Lithium-Ion Batteries

Preparation and Electrochemical Properties of LiNi<sub>2/3</sub>Co<sub>1/6</sub>Mn<sub>1/6</sub>O<sub>2</sub> Cathode Material for Lithium-Ion Batteries

Architecture and Performance of Anion-Doped Co-free Lithium-Rich Cathode Material with Nano-Micron Combined Morphology

Improving the Electrochemical Performance of LiNi1/3Co1/3Mn1/3O2 Cathode Material by LiF Modification