Abstract:Based on the vertical compressive static load test and pile mechanics test of three large diameter bored piles (one of the test piles was treated with postgrouting) in granite gneisses foundation, the bearing capacity, deformation characteristics, and influencing factors of the single pile under the limit state are analyzed and compared with the recommended values of survey report and the recommended values of current codes. By comparing the measured and theoretical values of pile axial force, the bearing capacity of cast-in-place pile under normal and limit conditions is analyzed. The experimental results show that theQ-scurve of large-diameter rock-socketed mud wall retaining bored pile with a length-diameter ratio of 25-33 and rock-socketed depth of 5-8 d shows a rapid growth. After grouting treatment, the ultimate compressive bearing capacity of single pile is improved, the maximum settlement is reduced by 6.6%, the rebound rate is reduced by 11.1%, and the settlement effect of controlling pile top is not significant. The bearing capacity and deformation characteristics of the three test piles are less affected by length-diameter ratio and rock-socketed depth. For postgrouting piles, the ratio of frictional resistance of rock-socketed segment and the ratio of pile lateral resistance are less affected by length-diameter ratio and rock-socketed depth, while, for postgrouting piles, the ratio of pile lateral resistance is more affected by rock-socketed depth. The pile end resistance ratio of the three test piles is significantly affected by the rock-socketed depth, whether or not the pile side postgrouting treatment is carried out.

Axial Compression Bearing Capacity of Frictional Single Pile

Assessment of design methods for axial bearing capacity of driven piles in clay

A NEW CALCULATION METHOD FOR LARGE-DIAMETER-TUBULAR-PILE BEARING CAPACITY

STUDY ON VERTICAL BEARING CAPACITY OF LARGE-DIAMETER CAST-IN-SITU THIN-WALL TUBULAR PILE

Model Tests on the Bearing Capacity of Precast Open-Ended Micro Pipe Piles in Soft Soil

Experimental Analysis of Bearing Capacity of Cast-in-place Tubular Pile

Study on Axial Bearing Properties of Cast-in-place Concrete Thin-Wall Tubular Piles

Model tests on the bearing capacity of precast oxen-ended micro pipe plies in sort soil

Experimental Study on Bearing Capacity Behavior of Deep Large Diameter Cast-in-place Belled Pile

Research on Axial Bearing Capacity and Reliability of Single Pile

A test on base bearing capacity of static drill rooted nodular pile

Analysis of Axial Load-Transfer of Large-Diameter Cast-in-situ Tubular Pile

Vertical Bearing Capacity of Large-Diameter Bored Pile

Analysis of Ultimate Bearing Capacity of X-section Cast-in-place Concrete Pile Composite Foundation under Rigid Load

ANALYSIS ON BEARING CAPACITY OF DIVING DRY-VIBRATION COMPACTION STONE PILES

RESEARCH ON INFLUENCE OF SOIL CORE ON BEARING CHARACTER OF LARGE-DIAMETER TUBULAR PILE USING CAST-IN-SITU CONCRETE

Vertical compressive bearing performance and optimization design method of large-diameter manually-excavated rock-socketed cast-in-place piles

Field Tests and Simplified Calculation Method for Static Drill Rooted Nodular Pile

Method for Calculating Vertical Compression Bearing Capacity of the Static Drill Rooted Nodular Pile

Investigation into Skin Friction of Bored Pile Including Influence of Soil Strength at Pile Base

Ultimate Load Tests On Bearing Behavior Of Large-Diameter Bored Piles In Weathered Rock Foundation